Netgear AXM751 Quick Start Manual

)NSTALLATION'UIDE

XFP GBIC Module AXM751

The 10 Gigabit small form-factor pluggable (XFP) module provides a
full-duplex 10G bps Ethernet link on NETGEAR managed switches.

The switch will automatically detect the AXM751, so you can simply
plug it into an available module slot.

The module can be inserted or removed while the switch is operational.

Installing a AXM751 Module

Insert the module firmly into the slot that supports the XFP interface.

Make sure the optical cable you use is multi-mode LC to LC duplex
cable.

Removing a AXM751 Module

Release the module latch by pulling down the handle bar across the
module, and pull the module out of the module slot.

Specifications

Standard IEEE 802.3ae

10GBase LR

Dimensions (HxWxD) 0.33” x 0.72” x 3.07”

(8.5mm x 18.35mm x 78.0 mm)

Weight 0.1 lb (47g)

Operating Temperature 32- 158 F (0-70c)

Storage Temperature 32-185 F (0-85c)

Operative relative humidity 104 (40c) and 90%

Operating Distance 33m (62um OM1 cable)

82m (50um OM2 cable)
220m (50um OM3 cable)

Connectors LC MM for 62.5um fiber cable

LC MM for 50um fiber cable

Power Consumption 0.95w (max: 1.37w)

MTBF 1154739 hr (135 years)

Safety Certification UL 1950

CSA 22.2 No. 950

Regulatory Compliance

The regulatory compliance details are documented below.

Statement of Conditions

Note: This device has being tested and found to comply with limits for a

Class B digital device, pursuant to part 15 of FCC rules. These limits
are designed to provide reasonable protection against harmful
interference in a commercial installation.

In the interest of improving internal design, operational function, and/or
reliability, NETGEAR reserves the right to change the product
described in this document without notice. NETGEAR does not assume
any liability that may accrue due to the use or application of the
product(s) or circuit layout(s) described herein.

Certificate of Manufacture/Importer

It is hereby certified the NETGEAR model AXM751 has being
suppressed in accordance with the condition set out in MBPT­Amtsb|Vfg 243/1991 and vfg 46/1992. The operation of some
equipment (for example, test transmitters) in accordance with regulation
may, however, be subject to certain restrictions. Please refer to the note
in the operating instructions. Federal Office for Telecommunications
Approvals has being notified of the placing of this equipment on the
market and has being granted the right to test the series for compliance
with regulation.

June 6, 2006

Laser Safety Warning

This is a Class 1 laser product.

Warning: Because invisible laser radiation may be emitted from aperture of

the port when no fiber cable is connected, avoid exposure to laser
radiation and do not stare into open aperture.

This symbol was placed in accordance with the European Union Directive
2002/96 on the Waste Electrical and Electronic Equipment (the WEEE
Directive). If disposed of within the European Union, this product should
be treated and recycled in accordance with the laws of your jurisdiction
implementing the WEEE Directive.

© 2006 by NETGEAR, Inc. All rights reserved. NETGEAR is a registered trademark of NET­GEAR, Inc. in the United States and/or other countries. Other brand and product names are
trademarks or registered trademarks of their respective holders. Information is subject to change
without notice.