NEC UPC2903HF, UPC2903HB, UPC2933T, UPC2933HF, UPC2912HF Datasheet

...

(

)

DATA SHEET

BIPOLAR ANALOG INTEGRATED CIRCUIT

PC2900 Series

THREE TERMINAL LOW DROPOUT VOLTAGE REGULATOR

The µPC2900 series of low dropout voltage three terminal positive regulators is constructed with PNP output

transistor. The µPC2900 series feature the ability to source 1 A of output current with a low dropout voltage of typically

0.7 V.

The power dissipation of the terminal positive voltage regulators that is constructed with NPN output transistor. Also, this series corresponds to the low voltage output (3 V, 3.3 V) which is not in the conventional low dropout regulators (µPC2400A series).

FEATURES

• Output current in excess of 1.0 A

• Low dropout voltage V

• On-chip overcurrent and thermal protection circuit

• On-chip output transistor safe area protection circuit

PC2900 series can be drastically reduced compared with the conventional three

DIF = 0.7 V TYP. (at IO = 1 A)

PIN CONFIGURATION (Marking Side)

PC2900HF Series: MP-45G

1: INPUT 2: GND 3: OUTPUT

PC2900HB Series: MP-3

PC2900T Series: MP-3Z

1: INPUT 2: GND 3: OUTPUT 4: GND

Fin

Document No. G10026EJ3V0DS00 (3rd edition) Date Published July 1998 N CP(K) Printed in Japan

The information in this document is subject to change without notice.

The mark shows major revised points.

1997

BLOCK DIAGRAM

Safe operating area protection

PC2900 Series

INPUT

Start-up circuit

Reference voltage

Thermal shut down

Error amp.

Drive circuit

Saturation protection

Over current protection

ORDERING INFORMATION

Part Number Package Output Voltage

PC2903HF MP-45G (Isolated TO-220) 3.0 V

PC2903HB MP-3 (SC-64) 3.0 V

PC2903T MP-3Z (SC-63) 3.0 V

PC2933HF MP-45G (Isolated TO-220) 3.3 V

PC2933HB MP-3 (SC-64) 3.3 V

PC2933T MP-3Z (SC-63) 3.3 V

PC2905HF MP-45G (Isolated TO-220) 5.0 V

PC2905HB MP-3 (SC-64) 5.0 V

PC2905T MP-3Z (SC-63) 5.0 V

PC2906HF MP-45G (Isolated TO-220) 6.0 V

PC2906HB MP-3 (SC-64) 6.0 V

PC2906T MP-3Z (SC-63) 6.0 V

PC2907HF MP-45G (Isolated TO-220) 7.0 V

PC2907HB MP-3 (SC-64) 7.0 V

PC2907T MP-3Z (SC-63) 7.0 V

PC2908HF MP-45G (Isolated TO-220) 8.0 V

PC2908HB MP-3 (SC-64) 8.0 V

PC2908T MP-3Z (SC-63) 8.0 V

PC2909HF MP-45G (Isolated TO-220) 9.0 V

PC2909HB MP-3 (SC-64) 9.0 V

PC2909T MP-3Z (SC-63) 9.0 V

PC2910HF MP-45G (Isolated TO-220) 10.0 V

PC2910HB MP-3 (SC-64) 10.0 V

PC2910T MP3Z (SC-63) 10.0 V

PC2912HF MP-45G (Isolated TO-220) 12.0 V

PC2912HB MP-3 (SC-64) 12.0 V

PC2912T MP-3Z (SC-63) 12.0 V

OUTPUT

GND

ABSOLUTE MAXIMUM RATINGS (TA = 25 °C, Unless otherwise specified.)

PC2900 Series

Parameter Symbol

Input Voltage VIN 20 V Internal Power Dissipation Operating Ambient Temperature TA –30 to +85 °C Operating Junction Temperature TJ –30 to +150 °C Storage Temperature Tstg –55 to +150 °C Thermal Resistance (Junction to Case) Rth (J-C) 7 12.5 °C/W Thermal Resistance (Junction to Ambient)

Note

PT 15 10 W

Rth (J-A) 65 125 °C/W

PC2900HF

Rating

PC2900HB, µPC2900T

Note TC = 25 °C, Internally limited

When operating junction temperature rises up to 150 °C, the internal circuit shutdown output voltage.

Caution Exposure to Absolute Maximum Ratings for extended periods may affect device reliability;

exceeding the ratings could cause permanent damage. The parameters apply independently. The device should be operated within the limits specified under DC and AC Characteristics.

TYPICAL CONNECTION

Unit

PC2900

INPUT

OUT

OUTPUT

CIN : More than 0.1 µF. Required if regulator is located an appreciable distance from power supply filter. You

must use to prevent from the parasitic oscillation.

OUT : More than 47

F. You must use the Low-impedance-type (low ESR) capacitor. D1 : Need for VO > VIN D2 : Need a shottky barrier diode for VO < GND.

PC2900 Series

RECOMMENDED OPERATING CONDITIONS

Parameter Symbol Type Number MIN. TYP. MAX. Unit

Input Voltage VIN

Output Current IO all 0 1.0 A Operating Ambient Temperature TA all –30 +85 °C Operating Junction Temperature TJ all –30 +125 °C

PC2903 4.0 16 V

PC2933 4.3 16

PC2905 6 16

PC2906 7 16

PC2907 8 16

PC2908 9 18

PC2909 10 18

PC2910 11 18

PC2912 13 18

ELECTRICAL CHARACTERISTICS µPC2903 (TJ = 25 °C, VIN = 5 V, IO = 500 mA, CIN = 0.22 µF, COUT = 47 µF, unless otherwise specified.)

Parameters Symbol Conditions MIN. TYP. MAX. Unit

Output Voltage VO 2.88 3.0 3.12 V

0 °C ≤ TJ ≤ 125 °C, 4.0 V ≤ VIN ≤ 16 V, 0 A ≤ IO ≤ 500 mA

0 °C ≤ TJ ≤ 125 °C, 0 A ≤ IO ≤ 1 A Line Regulation REGIN 4.0 V ≤ VIN ≤ 16 V 11 30 mV Load Regulation REGL 0 A ≤ IO ≤ 1 A 9 30 mV Quiescent Current IBIAS IO = 0 A 1.9 4.0 mA

IO = 1 A 23 60 Startup Quiescent Current IBIAS (s) VIN = 2.95 V, IO = 0 A 12 30 mA

VIN = 2.95 V, IO = 1 A 80 Quiescent Current Change ∆IBIAS Output Noise Voltage Vn 10 Hz ≤ f ≤ 100 kHz 52 Ripple Rejection R·R f = 120 Hz, 4.0 V ≤ VIN ≤ 16 V 48 63 dB Dropout Voltage VDIF 0 °C ≤ TJ ≤ 125 °C, IO = 1 A 0.7 1.0 V Short Circuit Current IO short VIN = 4.5 V 1.2 1.7 3.0 A

Peak Output Current IO peak VIN = 4.5 V 1.0 1.5 3.0 A

Temperature Coefficient of ∆VO/∆T0 °C ≤ TJ ≤ 125 °C, IO = 5 mA –0.5 mV/°C Output Voltage

0 °C ≤ TJ ≤ 125 °C, 4.0 V ≤ VIN ≤ 16 V

VIN = 16 V 1.2

VIN = 16 V 1.3 1.7 2.8

2.85 3.15

3.2 20 mA

Vr.m.s.

PC2900 Series

ELECTRICAL CHARACTERISTICS µPC2933 (TJ = 25 °C, VIN = 5 V, IO = 500 mA, CIN = 0.22 µF, COUT = 47 µF, unless otherwise specified.)

Parameters Symbol Conditions MIN. TYP. MAX. Unit

Output Voltage VO 3.17 3.3 3.43 V

0 °C ≤ TJ ≤ 125 °C, 4.3 V ≤ VIN ≤ 16 V, 0 A ≤ IO ≤ 500 mA

0 °C ≤ TJ ≤ 125 °C, 0 A ≤ IO ≤ 1 A Line Regulation REGIN 4.3 V ≤ VIN ≤ 16 V 12 33 mV Load Regulation REGL 0 A ≤ IO ≤ 1 A 23 33 mV Quiescent Current IBIAS IO = 0 A 2.0 4.0 mA

IO = 1 A 30 60 Startup Quiescent Current IBIAS (s) VIN = 3.1 V, IO = 0 A 10 30 mA

VIN = 3.1 V, IO = 1 A 80 Quiescent Current Change ∆IBIAS Output Noise Voltage Vn 10 Hz ≤ f ≤ 100 kHz 55 Ripple Rejection R·R f = 120 Hz, 4.3 V ≤ VIN ≤ 16 V 48 64 dB Dropout Voltage VDIF 0 °C ≤ TJ ≤ 125 °C, IO = 1 A 0.7 1.0 V Short Circuit Current IO short VIN = 4.5 V 1.2 1.6 3.0 A

Peak Output Current IO peak VIN = 4.5 V 1.0 1.4 3.0 A

Temperature Coefficient of ∆VO/∆T0 °C ≤ TJ ≤ 125 °C, IO = 5 mA –0.4 mV/°C Output Voltage

0 °C ≤ TJ ≤ 125 °C, 4.3 V ≤ VIN ≤ 16 V

VIN = 16 V 1.2

VIN = 16 V 1.3 1.7 2.8

3.14 3.46

3.0 20 mA

Vr.m.s.

PC2900 Series

ELECTRICAL CHARACTERISTICS µPC2905 (TJ = 25 °C, VIN = 8 V, IO = 500 mA, CIN = 0.22 µF, COUT = 47 µF, unless otherwise specified.)

Parameters Symbol Conditions MIN. TYP. MAX. Unit

Output Voltage VO 4.8 5.0 5.2 V

0 °C ≤ TJ ≤ 125 °C, 6 V ≤ VIN ≤ 16 V, 0 A ≤ IO ≤ 500 mA

0 °C ≤ TJ ≤ 125 °C, 0 A ≤ IO ≤ 1 A Line Regulation REGIN 6 V ≤ VIN ≤ 16 V 23 50 mV Load Regulation REGL 0 A ≤ IO ≤ 1 A 28 50 mV Quiescent Current IBIAS IO = 0 A 2.2 4.0 mA

IO = 1 A 30 60 Startup Quiescent Current IBIAS (s) VIN = 4.5 V, IO = 0 A 10 30 mA

VIN = 4.5 V, IO = 1 A 80 Quiescent Current Change ∆IBIAS Output Noise Voltage Vn 10 Hz ≤ f ≤ 100 kHz 90 Ripple Rejection R·R f = 120 Hz, 6 V ≤ VIN ≤ 16 V 46 61 dB Dropout Voltage VDIF 0 °C ≤ TJ ≤ 125 °C, IO = 1 A 0.7 1.0 V Short Circuit Current IO short VIN = 6.5 V 1.15 1.8 3.0 A

Peak Output Current IO peak VIN = 6.5 V 1.1 1.5 3.0 A

Temperature Coefficient of ∆VO/∆T0 °C ≤ TJ ≤ 125 °C, IO = 5 mA 0.6 mV/°C Output Voltage

0 °C ≤ TJ ≤ 125 °C, 6 V ≤ VIN ≤ 16 V

VIN = 16 V 1.1

VIN = 16 V 1.4 2.0 2.8

4.75 5.25

2.9 20 mA

Vr.m.s.

+ 14 hidden pages