Nascom N132FBLK-STHS, N132FBLK-STHS-D Specsheet

CONTACT RATINGS — ALARM CIRCUIT

N132F BLK/STHS

BLACK HORNET SWITCH

DESCRIPTION

Nascom’s Black Hornet is a high security switch and works off of ferrous metal. No magnet is needed. So you can protect your electronic rquipment:

computers, atscreen TV’s, monitors etc. There are endless applications for

the Black Hornet.

FEATURES

• MAGNASPHERE™ TECHNOLOGY

• INTRODUCING ANOTHER MAGNET TRIPS ALARM

• AVAILABLE WITH STICK ON FERROUS DISC OR WITHOUT

SPECIFICATIONS

PARAMETERS CONDITION MIN TYP MAX UNITS

Switching Voltage Switching Current Carry Current Contact Rating Life Expectancy Static Contact Resistance

Max DC/Peak AC Resistive Max DC/Peak AC Resistive Max DC/Peak AC Resistive Max DC/Peak AC Resistive

CIRCUIT INFORMATION

Alarm Circuit Closed Loop / Normally Open

SWITCH SPECIFICATIONS

Insulation Resistance Capacitance Dielectric Strength

100V, 25oC, 40% RH Across Open Contacts Between Contacts

ENVIRONMENTAL RATINGS

Storage Temperature Operating Temperature

WIRING SCHEMATIC

SWITCH CONTACT

1.00E+09

300

-35

1.00E+06

300

0.25

0.25 10

150

+110 +110

VDC Amps Amps

Ops

mOhms

(initial)

Ohms

Min VDC

Royne Industries LLC, dba Nascom

CLOSED LOOP, NORMALLY OPEN CONTACT

P: 800.843.5530

F: 800.727.4041

www.nascominc.com

DWG No. 131126-01 Rev. 0

DIMENSIONS - IN [mm]

N132F BLK/STHS

BLACK HORNET SWITCH

.145

3.68

.400

10.16

.390

9.91

TOP VIEW

SWITCH FRONT VIEW

.150

3.81

.090

2.29

.700

17.78

1.125

28.58

PART NUMBER DESCRIPTION

N132FBLK/STHS N132FBLK/STHS/D

BLACK HORNET SWITCH - NO TAPE DISC BLACK HORNET SWITCH -THE STICK ON TAPE DISC

TOP VIEW

MAGNET FRONT VIEW

.400

10.16

.090

2.29

.145

3.68

.700

17.78

1.125

28.58

.150

3.81

.575

14.61

INSTALLATION INSTRUCTIONS

(Note: tape disk references the /D option of the Black Hornet. With the tape disc, the Black Hornet should be

mounted directlhy to ferrous metal)

• Remove a screw from at surface on the item to be protected

• Use an alcohol swab to clean the surface where the tape disk will adhere.

• Remove the green and white backing for the tape disk.

• Run the screw through the switch mounting hole, and back into the original screw hole, making sure that the tape disk is located over the

area that has been cleaned.

• To insure that the tape disk is properly applied, remove the screw and switch then press the tape disk rmly onto the surface.

• Reinstall the switch, making sure the tape disk is inset in the counter-sunk hole in the underside of the switch.

WIRING INSTRUCTIONS

•The Black and White cable leads are the Alarm Contact. The Red and Green cable leads are the Supervisory Loop. The Supervisory Loop wires are agged for identication.

DWG No. 131126-01 Rev. 0

Royne Industries LLC, dba Nascom

P: 800.843.5530

F: 800.727.4041

www.nascominc.com