System Recovery (Windows 7) �����������������������������������������������������������������3-10
System Recovery (Windows8�x) ��������������������������������������������������������������3-20
3-7
Personal Computer
Copyright Notice
The material in this document is the intellectual property of MICRO-STAR
INTERNATIONAL� We take every care in the preparation of this document, but
no guarantee is given as to the correctness of its contents� Our products are
under continual improvement and we reserve the right to make changes without
notice�
Trademarks
All trademarks are the properties of their respective owners�
MSI is a registered trademark of Micro-Star Int’l Co�, Ltd�
■
Intel is a registered trademark of Intel Corporation�
■
Realtek is a registered trademark of Realtek Semiconductor Corporation�
■
Windows is a registered trademark of Microsoft Corporation�
■
Revision
Revision Date
V1�2 2013/ 10
iii
Preface
Upgrade and Warranty
Please note that certain components preinstalled in the product may be upgradable
or replaceable by user’s request� To learn more about upgrade limitation, please
refer to the specications in the User’s Manual� For any further information about
the product users purchased, please contact the local dealer� Do not attempt to
upgrade or replace any component of the product if you are not an authorized
dealer or service center, since it may cause the warranty void� It is strongly
recommended that you contact the authorized dealer or service center for any
upgrade or replace service�
Acquisition of Replaceable Parts
Please be noticed that the acquisition of replaceable parts (or compatible ones) of
the product users purchased in certain countries or territories may be fullled by
the manufacturer within 5 years at most since the product has been discontinued,
depending on the ocial regulations declared at the time�
Please contact the manufacturer via http://support�msi�com/ for the detailed
information about the acquisition of spare parts�
Technical Support
iv
If a problem arises with your system and no solution can be obtained from the user’s
manual, please contact your place of purchase or local distributor� Alternatively,
please try the following help resources for further guidance�
Visit the MSI website for technical guide, BIOS updates, driver updates
◙
and other information via http://www�msi�com/service/download/
Contact our technical sta via http://support�msi�com/
◙
Green Product Features
Reduced energy consumption during use and stand-by
◙
Limited use of substances harmful to the environment and health
◙
Easily dismantled and recycled
◙
Reduced use of natural resources by encouraging recycling
◙
Extended product lifetime through easy upgrades
◙
Reduced solid waste production through take-back policy
◙
Personal Computer
Environmental Policy
The product has been designed to enable proper reuse of
◙
parts and recycling and should not be thrown away at its
end of life�
Users should contact the local authorized point of collection
◙
for recycling and disposing of their end-of-life products�
Visit the MSI website and locate a nearby distributor for further recycling
◙
information�
◙
Users may also reach us at gpcontdev@msi�com for information
regarding proper Disposal, Take-back, Recycling, and Disassembly of
MSI products�
Chemical Substances Information
In compliance with chemical substances regulations, such as the EU REACH
Regulation (Regulation EC No� 1907/2006 of the European Parliament and the
Council), MSI provides the information of chemical substances in products at:
European Union:
Batteries, battery packs, and accumulators should not be
disposed of as unsorted household waste� Please use the
public collection system to return, recycle, or treat them in
compliance with the local regulations�
Taiwan:
For better environmental protection, waste batteries should
be collected separately for recycling or special disposal�
California, USA:
The button cell battery may contain perchlorate material and requires special
handling when recycled or disposed of in California�
For further information please visit:
http://www�dtsc�ca�gov/hazardouswaste/perchlorate/
Danger of explosion if battery is incorrectly replaced� Replace only with the
same or equivalent type recommended by the manufacturer�
v
Preface
Safety Instructions
Read the safety instructions carefully and thoroughly�
All cautions and warnings on the equipment or user’s manual should be
noted�
Keep the User’s Guide that comes with the package for future reference�
Keep this equipment away from humidity and high temperature�
Lay this equipment on a reliable at surface before setting it up�
vi
Make sure that the power voltage is within its safety range and has
◙
been adjusted properly to the value of 100~240V before connecting
the equipment to the power outlet� Do not disable the protective earth
pin from the plug� The equipment must be connected to an earthed
mains socket-outlet�
Always unplug the AC power cord before installing any add-on card
◙
or module to the equipment�
Always disconnect the AC power cord or switch the wall socket o if
◙
the equipment would be left unused for a certain time to achieve zero
energy consumption�
The ventilator on the enclosure is used for air convection and to prevent
the equipment from overheating� Do not cover the ventilator�
Do not leave the equipment in an unconditioned environment with a
storage temperature above 60OC (140OF) or below 0OC (32OF), which may
damage the equipment�
NOTE: The maximum operating temperature is around 40OC�
Personal Computer
Never pour any liquid into the opening that could damage or cause
electrical shock�
Place the power cord in a way that people are unlikely to step on it� Do not
place anything on the power cord�
When installing the coaxial cable to the TV Tuner, it is necessary to
ensure that the metal shield is reliably connected to protective earthing
system of the building�
Cable distribution system should be grounded (earthed) in accordance
with ANSI/NFPA 70, the National Electrical Code (NEC), in particular
Section 820�93, Grounding of Outer Conductive Shield of a Coaxial
Cable�
Always keep the strong magnetic or electrical objects away from the
equipment�
If any of the following situations arises, get the equipment checked by
service personnel:
The power cord or plug is damaged�
◙
Liquid has penetrated into the equipment�
◙
The equipment has been exposed to moisture�
◙
The equipment does not work well or you can not get it work according
◙
to user’s manual�
The equipment has dropped and damaged�
◙
The equipment has obvious sign of breakage�
◙
The optical storage devices are classied as CLASS 1 LASER PRODUCT� Use of
1�
controls or adjustments or performance of procedures other than those specied
is prohibited�
2�
Do not touch the lens inside the drive�
vii
viii
Preface
CE Conformity
Hereby, Micro-Star International CO�, LTD declares that this device is
in compliance with the essential safety requirements and other relevant
provisions set out in the European Directive�
FCC-B Radio Frequency Interference
Statement
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules�
These limits are designed to provide reasonable protection against
harmful interference in a residential installation� This equipment
generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications� However, there is no guarantee that
interference will not occur in a particular installation� If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the measures listed below:
Reorient or relocate the receiving antenna�
■
Increase the separation between the equipment and receiver�
■
Connect the equipment into an outlet on a circuit dierent from that to
■
which the receiver is connected�
Consult the dealer or an experienced radio/television technician for
■
help�
Notice 1
The changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment�
Notice 2
Shielded interface cables and AC power cord, if any, must be used in order to
comply with the emission limits�
VOIR LA NOTICE D’INSTALLATION AVANT DE RACCORDER AU RESEAU�
This device complies with Part 15 of the FCC Rules� Operation is subject to the
following two conditions:
this device may not cause harmful interference, and
1�
this device must accept any interference received, including interference that
2�
may cause undesired operation�
WEEE Statement
Under the European Union (“EU”) Directive on Waste Electrical and Electronic
Equipment, Directive 2002/96/EC, which takes eect on August 13, 2005, products
of “electrical and electronic equipment” cannot be discarded as municipal waste
anymore and manufacturers of covered electronic equipment will be obligated to take
back such products at the end of their useful life�
Chapter 1
Overview
Congratulations for purchasing the Wind Box DC111
(MS-B062) System� This system is your best slim PC
choice� With the fantastic appearance and ultrasmall form
factor, it can easily be set anywhere� The feature packed
platform also gives you an exciting PC experience�
Overview
Packing Contents
1-2
Wind Box Series
Driver/ Utility Disk
* Please contact us immediately if any of the items is damaged or missing�
* The illustrations are for reference only and your packing contents may slightly vary
depending on the model you purchased�
AC/DC Adapter
User Manual
& Quick Guide
AC Power Cord
Stand
System Overview
Front View
Personal Computer
1
1
1
1
9
Ventilator
1
The ventilator on the enclosure is used for air convection and to prevent the
equipment from overheating� Do not cover the ventilator�
Card Reader Drive
2
The built-in card reader may support various types of memory cards�
2
3
4
5
6
7
8
1-3
Power Button/ LED
3
Press the power button to turn the system on and o� The power LED glows
when the system is turned on and goes o when the system is shut down�
In terms of power saving, the LED blinks in S3 (Suspend to RAM) mode and
goes o in S4 (Suspend to Disk) mode� Pressing the system power button
will wake the system up from power saving mode�
1-4
Overview
USB 2�0 Port
4
The USB (Universal Serial Bus) port is for attaching USB devices such
as keyboard, mouse, or other USB-compatible devices� It supports up to
480Mbit/s (Hi-Speed) data transfer rate�
Headphone Jack
5
This is a connector for headphones�
Microphone Jack
6
This is a connector for microphones�
WLAN LED
7
This indicator glows green when WLAN function is enabled and glows blue
when WiMax function is enabled� The indicator goes out when this function
is disabled�
HDD LED
8
This indicator shows the activity status of the HDD� It ashes when the
system is accessing data on the HDD and remains o when no disk activity
is detected�
Stand
9
Use this stand to position your system on a at and stable surface� Another
way to position your system without stand is to lay your system horizontally
on the surface with the Power Button faces up to the top�
Rear View
®
1
Personal Computer
2
3
2
10
Card Reader Drive
1
The built-in card reader may support various types of memory cards�
Ventilator
2
The ventilator on the enclosure is used for air convection and to prevent the
equipment from overheating� Do not cover the ventilator�
VGA-Out Port
3
The DB15-pin female connector is provided for monitor�
4
HDMI-Out Port
The High-Denition Multimedia Interface (HDMI) is an all-digital audio/ video
interface capable of transmitting uncompressed streams� HDMI supports all
TV format, including standard, enhanced or high-denition video, plus multichannel digital audio on a single cable�
4
5
6
7
8
9
1-5
1-6
Overview
USB 2�0 Port (Optional)
5
The USB (Universal Serial Bus) port is for attaching USB devices such
as keyboard, mouse, or other USB-compatible devices� It supports up to
480Mbit/s (Hi-Speed) data transfer rate�
USB 3�0 Port (Optional)
The USB 3�0 port is backward-compatible with USB 2�0 devices� It supports
up to 5Gbit/s (SuperSpeed) data transfer rate�
RJ-45 LAN Jack
6
The standard RJ-45 LAN jack is provided for connection to the Local Area
Network (LAN)� You can connect a network cable to it�
YellowGreen/ Orange
LEDColorLED StateCondition
Right Yellow OLAN link is not established�
On (steady state)LAN link is established�
On (blinking)The computer is communicating with
LeftGreen O10 Mbit/sec data rate is selected�
On100 Mbit/sec data rate is selected�
Orange On1000 Mbit/sec data rate is selected�
another computer on the LAN�
Speaker Jack
7
This is a connector for speakers�
Optical S/PDIF-Out Jack
8
This S/PDIF (Sony & Philips Digital Interconnect Format) jack is provided
for digital audio transmission to external speakers through an optical ber
cable�
Power Jack
9
The AC/DC adapter converts AC power to DC power for this jack� Power
supplied through this jack supplies power to your personal computer� To
prevent damage to the PC, always use the supplied power adapter�
Personal Computer
Stand
10
Use this stand to position your system on a at and stable surface� Another
way to position your system without stand is to lay your system horizontally
on the surface with the Power Button faces up to the top�
Important
1� We suggest that you connect the AC/DC adapter to your system rst and then connect
the AC power cord to the socket-outlet for safety concerns�
2� High-speed devices are recommended for USB 3�0 ports whereas low-speed devices,
such as mouse or keyboard, are suggested to be plugged into the USB 2�0 ports�
1-7
Loading...
+ 33 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.