Installation Instructions
Wireless Motion Sensor LED Mini Spotlight
MB300 / MB310
Thank you for purchasing the Mr Beams
®
Wireless Mini Spotlight. We are committed to
eliminating darkness using the latest in
Light-Emitting Diodes (LEDs). LEDs are the most
ecient and durable light sources available. We
are certain that your light will contribute to a safer
Tips:
•
•
•
•
batteries to settle, then test activation.
•
environment and provide light where you need it at
a very reasonable cost.
What is included per light:
• 1 Wireless Spotlight
• Mounting Base
• 2 Screws
• 2 Anchors
What you need to install:
• 1 Small Screwdriver
• 3 C-Cell Alkaline Batteries
Spotlight Features:
Motion/Light Sensor: Light instantly turns on when it detects
motion from up to 25 feet away. The light sensor conserves battey
life by preventing the light from activating in daylight.
Auto Shut-o: Light shuts o automatically after 30 seconds if no
motion is detected.
Adjustable: Bracket allows light to angle up or down.
Bright LED: 80 Lumens covers up to 350 sq ft.
Durable, Weather Resistant: Tight seals and UV resistant material
allow the light to work in all weather conditions.
Use only new alkaline C- Cell batteries with 1.5V rating.
Do not mix old and new batteries. If batteries are not new, it may cause the light to malfunction.
Install batte ries with pola rity in correct position.
Light may activate when bat teries are inserted. Simply take light into a dark room. Allow
If your light will not turn o, it means that it is time to replace the batteries.
Mouting
Bracket
Mounting Bracket
Post
Motion &
Light Sensor
LED Light
Thumb Screw
NOTE: Light sensor only allows Spotlight to activate in darkness. We recommend you test in a dark room or closet.
Set Up
Locked
1. Unscrew thumbscrew on mounting bracket by
turning counter-clockwise and set aside.
2. Tilt bracket back slightly. 3. Push bracket down toward light
to unlock from keyhole.
4. Gently pull up on post side of
bracket and lift o of light.
Install/Change Batteries
5. Remove front cover of spotlight by unscrewing counter-clockwise. Pull face from
cup to reveal battery holder.
6. To release batter y door push into the tab on the cover and pull up. Inser t 3
C-Cell batteries, with at side to spring. Attach batter y door by inser ting tabs
into the rectangualr holes then push down on front until door clicks into place.
Mounting Spotlight
8. Determine
mounting
location and
drive two screws
directly through
two hole s in
the mounting
bracket.
Battery Caution:
1) Do not mix ol d and new b atter ies
2) Do not mix Alkaline, Sta ndar d (Carbon-Zinc) or Rech argea ble (Nickel Ca dmium) or (Ni ckel Met al Hydr ide) bat teri es
3) Do not di spose of batte ries i n re
4)Batteries shoul d be recyc led or dispos ed of as pe r state a nd loca l guideline s
www.mrbeams.com
9. First, slide
the post into the
bracket, then slide
down into the
locked position.
10. Align opposite
end with the screw
to the hole.
600 Beta Drive , Mayeld Vil lage, Unit 100, May eld , OH 44143
7. Screw face of spotlight back
into the cup by turning clockwise 3
full rotations until tightly closed.
* Visit our website to view installation video.
* 1 year limited warranty. Visit site for details.
11. Choose
preferred
angle of light,
then tighten
thumbscrew
to lock in
position.
877.298.9082
Loading...