Mr Beams MB860, MB850 User Manual
Installation Instructions
Stick Anywhere Task Light
MB850 / MB860
Thank you for purchasing the Mr Beams
®
Slim Light. We are committed to eliminating
darkness using the latest in Light-Emitting Diodes
(LEDs). LEDs are the most ecient and durable
light sources available. We are certain that your
light will contribute to a safer environment and
provide light where you need it at a very
reasonable cost.
What is included per light:
• 2 Slim Lights
• 4 Screws & 2 Strips of Double Sided Tape
• 2 Mounting Brackets
What you need to install:
• 4 AA-Cell Alkaline Batteries
• Screwdriver
Slim Light Features:
Motion/Light Sensor: Light instantly turns on when it
detects motion from up to 7 feet away. The light sensor
conserves battey life by preventing the light from
activating in daylight.
Auto Shut-o: Light shuts o automatically after 20 or 60
seconds (optional) if no motion is detected.
Bright LED: 35 Lumens covers up to 10 sq ft.
Tips:
•
Use only new alkaline AA-Cell batteries with 1.5V rating.
•
Do not mix old and new batteries. If batteries are not new, it may cause the light to malfunction.
•
Install batteries with polarity in correct position.
•
Light may activate when batteries are inserted. Simply take light into a dark room. Allow
motion sensor to settle, then test activation.
•
If your l ight is acti vating by motion too often, reposition lig ht fur ther away fr om trac.
Batteries will d rain if this keeps occurring.
•
If your light will not turn o, it means that it is time to replace the batteries.
•
NOTE: This is a strong adhesive tape that may cause damage to paint,
wallpaper, or surface underneath if removed.
Mounting Bracket Motion S ensor Sticker
LED Light
Motion &
Light S ensor
NOTE: Light sensor only allows Slim Light to activate in darkness. We recommend you test in a dark room or closet.
1. Remove rear cover of light by placing two
nger s on the circle on the face of the light and
placing your thumbs on each side of the back of
the light, lightly push down and slide toward the
arrows on mounting bracket.
5. Locate the motion sensor sticker.
Sticker will help optimize batter y life
and acts as a light sensor.
Battery Caution:
1) Do not mix ol d and new batteries
2) Do not mix Alkali ne, Sta ndard (C arbon -Zinc) or R echar geabl e (Nicke l Cadmiu m)
or (Nic kel Meta l Hydrid e) batte ries
3) Do not di spose o f batteries in re
4)Batteries s hould b e recycl ed or dis posed o f as per st ate and local gui delin es
www.mrbeams.com
6. Peel the yellow paper o motion
sensor sticker.
2. Set auto shut-o to 20 or 60
seconds. For extended batter y life,
20 seconds is recommended.
7. Apply sticker with hole centere d
over motion sensor lens.
3. Insert 4 AA-Cell batteries into Slim Lights. Lights should come
on immediately. Do not replace cover.
4. Drive screws (included) through holes of mounting bracket to
secure.
8. Turn the light so the motion
sensor lens is positioned closest to
walkway/front of cabinet. The best
location is as far away from walkway
/front of cabinet, while still
illuminating target surface space.
* Visit our website to view installation video.
* 1 year limited warranty. Visit site for details.
600 Beta Drive, Unit 100, Mayel d Villag e, OH 44143
877.298.9082
Loading...