Mr Beams MB560 User Manual

Installation Instructions

Compact Path Light

MB560

Thank you for purchasing the Mr Beams

®

Compact Path Light. We are committed to
eliminating darkness using the latest in Light­Emitting Diodes (LEDs). LEDs are the most ecient
and durable light sources available. We are certain

that your light will contribute to a safer environment
and provide light where you need it at a very
reasonable cost.

What is included per light:

• 2 Screws

• 1 Stake

What you need to install:

• 1 Small Screwdriver

• 4 AA-Cell Alkaline Batteries

(per light)

Path Light Features:

Motion/Light Sensor: Light instantly turns on when it
detects motion from up to 12 feet away. The light sensor
conserves battery life by preventing the light from
activating in daylight.

Auto Shut-o: Light shuts o automatically after 20
seconds if no motion is detected.

Bright LED: 30 lumens cover up to 50 sq ft.
Durable, Weather Resistant: Tight seals and UV resistant

material allow the light to work in all weather conditions.

Tips:

•

Use only new alkaline AA-Cell batteries with 1.5V rating.

•

Do not mix old and new batteries. If batteries are not new, it may cause the light to malfunction.

•

Install batteries with polarity in correct position.

•

Light may activate when batteries are inserted. Simply take light into a dark room. Allow

batteries to settle, then test ac tivation.

•

If your light will not turn o, it means that it is time to replace the batteries.

A. Mounting with Stake

LED Light

Motion & L ight

Sensor

Stake/

Mounting
Bracket

B. Mounting on Wall

Stake/

Mounting
Bracket

NOTE: Light sensor only allows light to activate in darkness. We recommend you test in a dark room or closet.

Battery Installation

1. Light comes with stake
attached. Remove by
sliding light out of stake.

Mounting with Stake Mounting on Wall

Battery Caution:

1) Do not mix ol d and new batteries

2) Do not mix Alkali ne, Sta ndard (C arbon -Zinc) or R echar geabl e (Nicke l Cadmiu m)
or (Nic kel Meta l Hydrid e) batte ries

3) Do not di spose o f batteries in  re

4) Batte ries sh ould be r ecycle d or disp osed of a s per sta te and local guideline s

2. Twist screwdriver
counter clockwise to
remove screw from
bottom of light.

A. Determine location for
mounting light. Place

piece of wood on top
of stake and gently
hammer into ground
with a hammer or soft

mallet. Slide path light

into stake until it is
seated securely.

3. Remove batter y compa rtme nt

lid by taking your index nge r

and lif ting the tab.

4. Inser t 4 AA-Cell batteries

according to the position
indicated on the light.

5. Depress the batter y lid
and twist screw back onto
light with screwdriver.

Determine mounting

B.

location. Drive two screws
(included) through holes

of mounting bracket. Once

mounted on wall, slide path
light down into stake until it
is securely seated.

www.mrbeams.com

* Visit our website to view installation video.

* 1 year limited warranty. Visit site for details.

600 Beta Drive, Unit 100, Mayel d Villag e, OH 44143

877.298.9082