Mr Beams MB542 User Manual

Wireless Motion Sensor LED Stair/Step Light

Motion Sensor Removal Instructions

MB542

Important: These instructions can only be used with Mr. Beams products that come with a remote.

Before you begin, these instructions are for customers who only wish to activate their light via remote control. By remov­ing the motion sensor, your light will no longer activate with motion. The auto-shut off timer will still turn the light off after
selected time. These instructions are not for those who are looking for a light to stay on for long periods of time. Please
note that once the sensor is removed, your warranty is void. We appreciate your interest in our products and

are more than happy to help you customize your light for your specic need. Please call or email any questions to
our customer service. Phone: [phone] Email: [e-mail]

1. Remove rear cover of Path Light by removing 2
screws on back.

Motion Sensor

3. Flip battery compartment over to reveal circuit
board. The motion sensor can be removed with
needle nose pliers, gently twisting until it detach­es from unit.

2. Open lid to reveal battery compartment and
remove six screws. Pull battery compartment out
at the seam to separate from face of light.

Light Sensor

4. Remove light sensor with needle nose pliers,
gently twisting until it detaches. Replace battery
compartment into the light. Screw six screws
securely and replace the battery door. See your
user manual for installation instructions.

www.mrbeams.com

32333 Au rora Rd. Suite 100 So lon, OH 4 4139

877.298.9082