Mr Beams MB390, MB380 User Manual
Installation Instructions
Wireless Motion Sensor LED UltraBright Spotlight
MB380-390
Thank you for purchasing the Mr Beams
®
Wireless UltraBright Spotlight. We are committed
to eliminating darkness using the latest in
Light-Emitting Diodes (LEDs). LEDs are the most
ecient and durable light sources available. We
are certain that your light will contribute to a safer
environment and provide light where you need it at
a very reasonable cost.
What is included per light:
• 1 Wireless UltraBright Spotlight
• 3 Screws
• 3 Anchors
What you need to install:
• 1 Small Screwdriver
• 4 D-Cell Alkaline Batteries
Spotlight Features:
Motion/Light Sensor: Light instantly turns on when it
detects motion from up to 25 feet away. The light sensor
conserves battery life by preventing the light from activating
in daylight.
Auto Shut-o: Light shuts o automatically after 20
seconds if no motion is detected.
Fully Adjustable: Motion Sensor Spotlight can be
rotated 360° as well as up and down.
Bright LEDs: 300 Lumens covers up to 400 sq ft.
Durable, Weather Resistant: Tight seals and UV resistant
material allow the light to work in all weather conditions.
Tips:
•
Use only new alkaline D-Cell batteries with 1.5V rating.
•
Do not mix old and new batteries. If batteries are not new, it may cause the light to malfunction.
•
Install batteries with polarity in correct position.
•
Light may activate when batteries are inserted. Simply take light into a dark room. Allow
batteries to settle, then test ac tivation.
•
If your light will not turn o, it means that it is time to replace the batteries.
LED Lights
Motion &
Light Sensor
Mounti ng Base
Thumb Screw
Knuckle Screw
Mounting Base
NOTE: Light sensor only allows light to activate in darkness. We recommend you test in a dark room or closet.
1. Remove front cover of Spotlight by rotating
counter-clock wise as shown above. Pull face out
from cup to reveal battery holder.
4. Remove mounting base by turning thumb
screw counter-clockwise. Pull mounting base o
stem of light.
5. Drive three screws into three holes to mount
the mounting base. For best results, drill pilot
holes rst and inser t anchors.
Battery Caution:
1) Do not mix ol d and new batteries
2) Do not mix Alkali ne, Sta ndard (C arbon -Zinc) or R echar geabl e (Nicke l Cadmiu m)
or (Nic kel Meta l Hydrid e) batte ries
3) Do not di spose o f batteries in re
4)Batteries s hould b e recycl ed or dis posed o f as per st ate and local gui delin es
www.mrbeams.com
2. Separate two parts by squeezing tabs and pulling
apart.
6. Insert spotlight back into mounting base pointed in
the desired direction. Tighten mounting base thumb
screw.
3. Insert 4 D- Cell batteries into Spotlight. Attach
holder by aligning the grooves on the side and
match white arrows, snapping both tabs in the
holder.
7. To pivot Spotlight up and down, loosen knuckle
screw in the joint of the Spotlight stem and adjust
Spotlight head to proper direction. Tighten
knuckle screw.
* Visit our website to view installation video.
* 1 year limited warranty. Visit site for details.
32333 Au rora Rd. Suite 100 So lon, OH 4 4139
877.298.9082
Loading...