Mr Beams MB3000 User Manual

Installation Instructions

High Performance Security Light

MB3000

What is included per light:

• 3 screws & 3 anchors

• Mounting bracket

What you need to install:

• 4 D-cell alkaline batteries

• 1 screwdriver (Phillips)

Tips:

•

Use only new alkaline D- Cell batteries with 1.5V rating.

•

Do not mix old and new batteries. If batteries are not new, it may cause the light to malfunction.

•

Install batteries with polarity in correct position.

•

Light may activate when bat teries are inserted. Simply take light into a dark room,

allow batteries to settle, then test activation.

•

If your light will not turn o, it means that it is time to replace the batteries.

• 1 screwdriver (athead)

• Drill (1/4” drill bit for dr ywall installation)

Spotlight Features:

Motion/Light Sensor: The light instantly turns on when it
detects motion from up to 30 feet away. The light sensor
conserves battery life by preventing the light from activating
in daylight.

Auto Shut-o: Light shuts o automatically af ter
20 seconds if no motion is detected.

Bright LED: 500 lumens cover up to 800 sq ft.
Durable, Weather Resistant: Tight seals and UV resistant

material allow the light to work in all weather conditions.

NOTE: Light sensor only allows light to activate in darkness. We recommend you test in a dark room or closet.

LED Light

LED Light

Motion & L ight

Sensor

1. To remove the back plate from the light, use

your nger to push up on the mounting bracket

tab. This will unlock the bracket. Then slide the

bracket down o the back of the light.

4. Replace the bat tery lid and
make sure the screws are
twiste d in tightly.

Battery Caution:

1) Do not mix ol d and new b atter ies

2) Do not mix alkali ne, sta ndard (c arbo n-zinc) or r echargeable (nicke l cadmi um) or
(nickel m etal hyd ride) ba tteries

3) Do not di spose o f batte ries in  re

4) Batte ries should be r ecycled or dis posed o f as per st ate and l ocal gu ideli nes

www.mrbeams.com

5. Before mounting your light, test the motion sensor
in a dark closet or bathroom. Close the light in the dark
room and leave for up to 5 minutes. When you re-enter

the room, the light should activate with motion.

2. Use a screwdriver to loosen the four
screws on the back plate. The screws
will not come out all the way.

3. Lift the battery lid o the back of the light. Insert 4 D- Cell
batteries with the at ends against the springs.

6. Determine mounting location for the
light. Place the mounting plate on the

surface so that the tab is pointing down
and mark the pilot holes for dry wall.
Use a drill to inser t the anchors, then
line up the mounting plate with the
holes and drill screws in.

* Visit our website to view installation video.

* 1 year limited warranty. Visit site for details.

32333 Au rora Rd. Suite 100, S olon, OH 44139

7. Line up the light with the
mounting plate and slide the
light into the grooves.

877.298.9082