Moultrie MFHP81565, MFHP81693 User Manual

Instructions for Econo Plus Feeder Kit

THANK YOU for your purchase of the Econo Plus Feeder Kit.

Please read this sheet before operating the unit. If you should have
any questions about this product or any other Moultrie product,
please contact us using the information below. To help us to better
serve you, please complete and mail the enclosed Warranty Card.

DRILLING YOUR DRUM/BARREL/BUCKET

Econo Plus Feeder will mount to the bottom of any drum or bucket

caution: wear eye protection

Turn drum over, measure and mark the center of the bottom.

Center the template on the bottom of the drum and secure
with tape. Drill two 3/16" Funnel holes and three 5/16"
Feeder Leg holes.

Using a Hole Saw, drill a 2-1/4" hole in the center of the
bottom of your drum.

MOUNTING THE FEEDER

Short

Bolts

Place Funnel inside Drum with
small end of funnel facing down,
and attach with two Short Bolts
using nuts and washers provided.

Drum

Funnel Holes

Feeder Leg Holes

Bolts

Turn Drum upside down.

Place Feeder on Drum.
Attach Feeder Legs to Drum as
shown with Long Bolts using
nuts and washers provided.

Funnel

Feeder

Feeder Legs

Long

Bolts

Drum

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna• Increase the separation between the equipment and the receiver

•

You can regulate the amount of feed
dispensed by setting the switches to
the desired Run Time as shown in
chart on right. Amount of feed is
approximate and will vary.

Your Econo II feeds two times per
day, once shortly after daybreak and
again in the evening. The evening
feed time is modifiable as shown in
chart on right.

caution: wear eye protection

FEEDER WILL SPIN 5 SECONDS
AFTER BATTERY IS FIRST
CONNECTED AND WILL SPIN
AGAIN WHEN THE LIGHT LEVEL
CHANGES. Feeder will then be disabled

for 7 hours to prevent accidental feedings
due to cloud cover or lightning.

Feed approximately 30 minutes before dark.

Feed just before dark

Remove bottom and install a 6-Volt Alkaline (ex.
Energizer

TM

) or Moultrie rechargeable battery by
attaching the Red Alligator Clip to the positive
terminal (+) and the Black Alligator Clip to the
negative (-) terminal. Place bottom on unit and secure
using wing nut. Unit is now ready for operation.

6

.................MFHP81565

.....................................MFHP81693

120704R05 / MFK-EPK