Moultrie 120704R04 - MFH-PEK User Manual

Instructions for Econo Plus Feeder Kit

THANK YOU for your purchase of the Econo Plus Feeder Kit.

Please read this sheet before operating the unit. If you should have
any questions about this product or any other Moultrie product,
please contact us using the information below. To help us to better
serve you, please complete and mail the enclosed Warranty Card.

DRILLING YOUR DRUM/BARREL/BUCKET

Econo Plus Feeder will mount to the bottom of any drum or bucket

caution: wear eye protection

Turn drum over, measure and mark the center of the bottom.

Center the template on the bottom of the drum and secure
with tape. Drill two 3/16" Funnel holes and three 5/16"
Feeder Leg holes.

Using a Hole Saw, drill a 2-1/4" hole in the center of the
bottom of your drum.

MOUNTING THE FEEDER

Short

Bolts

Place Funnel inside Drum with
small end of funnel facing down,
and attach with two Short Bolts
using nuts and washers provided.

Drum

Funnel Holes

Feeder Leg Holes

Bolts

Turn Drum upside down.

Place Feeder on Drum.
Attach Feeder Legs to Drum as
shown with Long Bolts using
nuts and washers provided.

Funnel

Feeder

Feeder Legs

Long

Bolts

Drum

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna• Increase the separation between the equipment and the receiver

•

INSTALLING BATTERY

caution: wear eye protection

Remove bottom and install a 6-Volt Alkaline
(ex. Energizer

TM

) or Moultrie rechargeable
battery by attaching the Red Alligator Clip to
the positive terminal (+) and the Black
Alligator Clip to the negative (-) terminal.
Place bottom on unit and secure using wing
nut. Unit is now ready for operation.

SETTING TIME OF DAY

To set the current time, press the UP or DN buttons on the right side of the Timer. Hold button down to
advance quickly. Press button repeatedly to select a specific minute. The lights on left side of the display
indicate AM or PM.

MORNING AFTERNOON

Time Set buttons

AM / PM Indicator lights

Your Pro Econo is equipped with a power saving feature which turns off the display after
15 seconds of inactivity. The display does not need to be on in order for the feeder to
operate. Press the UP or DN button to turn the display back on.

SETTING FEED TIMES, RUN TIME AND TEST FEEDER

FEED TIMES: The Pro Econo allows you to feed up to 16 times per day between the
hours of 5:00am and 8:00pm. To select the times to feed, slide the switch to the “ON”
position that correspnds to the hour(s) desired.

The illustration on the right indicates that the Timer will
feed at 5:00 am, 12:00 pm (noon), and 5:00 pm

RUN TIME: The motor Run Time adjustment allows you to adjust the amount of feed dispensed.
To adjust Run Time, press and release the UP and DN buttons simultaneously. Once displayed, the
Run Time may be adjusted by pressing the UP or DN buttons.

MORNING AFTERNOON

4681012141618

RUN TIME (sec.)
Approx. feed dispensed (lbs.)

2

.75 1 1.5 2 2.5 3 3.5 4

.25

20

4.5

FEEDER TEST: To test the motor, press and hold UP and DN buttons simultaneously until a“5”

appears on the left hand side of the display. You now have 5 seconds to get away from the feeder
before the motor runs for the RUN TIME selected.

1: (Q) What battery should I use? (A) For best performance, use a
rechargeable 6-Volt, 5 Amp-Hour Moultrie brand battery. If
disposable batteries will be used, Energizer
recommended.

TM

Alakaline batteries are

2: (Q) What should I do if the timer isn't working? (A) Check the
connections to the battery to make sure alligator clips have not come
loose. Then check the battery itself by changing to a known good
battery. If the problem still persists, call Moultrie Customer Service
at the number below.

120704R04 / MFH-PEK