Motorola V3 Service Manual

Motorola GmbH, CSS Center Flensburg, Mobile Devices

Doc. No: V3_DISP_1
Version: 1.0
Date: 26.07.2005

Title: Disassembly/Assembly Instruction V3 CLI Display

Page: 1 / 7

Repair Support Information

© Copyright 2003-2005 Motorola Inc. All Rights reserved.
Motorola internal use

Disassembly and Assembly

Procedure

CLI-Display

V3

Created by Helmut Hansen

Motorola GmbH, CSS Center Flensburg, Mobile Devices

Doc. No: V3_DISP_1
Version: 1.0
Date: 26.07.2005

Title: Disassembly/Assembly Instruction V3 CLI Display

Page: 2 / 7

Repair Support Information

© Copyright 2003-2005 Motorola Inc. All Rights reserved.
Motorola internal use

1. Open the flip by removing the 4 screws, which are covered by 4 rubber-pieces.

2. Remove the CLI lens by using a black-pen (plastic)

Motorola GmbH, CSS Center Flensburg, Mobile Devices

Doc. No: V3_DISP_1
Version: 1.0
Date: 26.07.2005

Title: Disassembly/Assembly Instruction V3 CLI Display

Page: 3 / 7

Repair Support Information

© Copyright 2003-2005 Motorola Inc. All Rights reserved.
Motorola internal use

3. Remove the plug in the upper left corner as shown in the picture below. Orientation of the
board is also shown in the picture

4. Loosen the flex-print very carefully as shown in the picture below. As the side-keys, which
are also part of the flex-print are glued to the housing it is recommended to warm them up
slightly. If that is done it is relatively easy to loosen the side-keys from the housing. Please
take care for the rubber-pieces beside the side-keys as You can not order them when they are
lost. (Side-keys)