Motorola IDEN I50SX user Manual

i50sx Faceplates and Keypads

Your i50sx phone comes with a standard faceplate and keypad. You can order
additional face plates and keypads to changethe look of your phone.

The following steps and accompanying illustration detail the procedure for
removing and replacing thechangeable faceplate and keypad.

NOTE:Before replacing the faceplate, ensure that the audio seal and

keypad are present and undamaged. For security and
operational reasons, power to the i50sx phone should be off
prior to performing the removal and replacement procedure.
There is a protective plastic liner over the lens. Peel off prior to
operation.

Removal and Replacement Procedure

1

While holdingthe back of the phone, press the faceplate release button
located at the bottom ofthephone to release the faceplate.

2

In an upward motion, grasp the bottom part ofthefaceplate and detach
it from the phone, while also detaching the upper part of the faceplate
from the phone.

3

Remove the keypadfrom the phone(orfrom the faceplate).

4

To replace the faceplate and keypad, lay the keypad on the phone body.

5

As shownin the illustration,attach the faceplate to thephone body, first
at thetop and thenat the bottom. Rotatefaceplate towardsbottom ofthe
phone until the lower snap is engaged. Snap engagement will be
verifiedby a click sound. Afterthe lower snap is engaged, verifythat
the upper snap is engaged by pressing the earpiece area.

6

Re-apply powerto the phone by pressing the power button located on
the top of the phone.

Phone Body

Faceplate Release Button

Faceplate

Keypad