Motorola IDEN I30SX user Manual

i30sx Faceplates and Keypads

Your i30sx phone comes with a standard faceplate and keypad.You can order
additional face plates and keypads to changethe look of your phone.

The following steps and accompanying illustration detail the procedure for
removing and replacing thechangeable faceplate and keypad.

NOTE:Before replacing the faceplate, ensure that the keypadis

present and undamaged. For security and operational reasons,
power to the i30sx phone should be off prior to performing the
removal and replacement procedure. T here is a protective
plastic linerover the lens. Peeloff priorto operation.

Removal and Replacement Procedure

1

While holdingthe back of the phone, press the
faceplatereleasebuttonlocatedat thebottom of
the phone to release the faceplate. When you
press the release button,ensure that bothsides
are disengaged from the faceplate priorto
removal.

2

In an upward motion, grasp the bottom part ofthe faceplateand detach
it from the phone.

3

Remove the keypad from the phone (orfrom the faceplate).

Release Button

135

4

To replace the faceplate and keypad, lay the keypad on the phone body.

5

As shownin the illustration,attach the faceplate to thephone body, first
at the top and thenatthe bottom. Thetop of the faceplate needs to be
securely seated into the top of the phone. Rotate faceplate towards
bottom of thephone until the lowersnaps are engaged.Snap
engagement will be verified by a clicking sound. After thelower snaps
are engaged, verify that the middle of the faceplateis engaged by
pressing the faceplate nearthe s and r keys. This willbe verified by
a clicking sound.

6

Re-apply powerto the phone by pressing and holdingp near the
bottom of the phone until the statuslight glows red and a tone briefly
sounds.