Motorola DSR530, DSR207, dsr 317, DSR505 User Manual

USER GUIDE

Digital Satellite Receiver

Models DSR207, DSR317, DSR505, and DSR530

CONTENTS

IMPORTANT SAFETY INSTRUCTIONS ..........................................................................................1

DSR BASICS — SYMBOLS/ICONS ...............................................................................................6

Front Panel ............................................................................................................................6

Back Panel ............................................................................................................................7

CONNECTING YOUR DSR..........................................................................................................10

i

IMPORTANT SAFETY INSTRUCTIONS

Important Safety Instructions

• Read these instructions.

• Keep these instructions.

CAUTION

RISK OF ELECTRIC SHOCK

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

WARNING

TO REDUCE THE RISK OF FIRE OR ELECTRICAL
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.

CAUTION

TO PREVENT ELECTRICAL SHOCK, MATCH THE
BLADE OF THE PLUG TO THE WIDE SLOT AND
FULLY INSERT IN RECEPTACLE.

• Heed all warnings.

• Follow all instructions.

• Do not use this apparatus near water.

• Clean only with dry cloth.

• Do not block any ventilation openings. Install in

accordance with the manufacturer’s instructions.

• Do not install near any heat sources such as

radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.

• Do not defeat the safety purpose of the polarized

or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding­type plug has two blades and a third grounding
prong. The wide blade or the third prong is
provided for your safety. If the provided plug does

1

IMPORTANT SAFETY INSTRUCTIONS

not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.

• Protect the power cord from being walked on or

pinched, particularly at plugs, convenience
receptacles, and the point where they exit from the
apparatus.

• Use only attachments and accessories specified by

the manufacturer.

• Unplug this apparatus during lightning storms or

when unused for long periods of time.

• Refer all servicing to qualified service personnel.

Servicing is required when the apparatus has been
damaged in any way, such as when the power­supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.

2

Repairs

If you find the unit in need of repair, contact Star
Choice for repair or replacement.

Damage Requiring Service. Unplug this equipment
from the power source, and contact a qualified
service provider if any of the following situations
occurs:

• If the power supply cord or plug is damaged.

• If liquid or objects have fallen into the unit.

• If the unit became wet from rain or water.

• If the unit was dropped or damaged.

• If the unit’s performance changes.

Service. Do not try to service this product yourself. If
you open or remove the cover, you may be exposed
to dangerous voltage or other hazards and may void
the unit’s warranty. Contact a qualified service
provider for all service.

IMPORTANT SAFETY INSTRUCTIONS

Replacement Parts. If replacement parts are
required, be sure the service technician uses
replacement parts specified by the manufacturer or
have the same characteristics as the original part.
Unauthorized substitution may result in risk of fire,
electric shock, or other hazards.

Safety Check. After the unit is serviced or repaired,
ask the service technician to perform safety checks
to find out if the unit is in proper operating condition.

Regulatory Information

Federal Communications Commission Radio and
Television Interface Statement for a Class ‘B’ Device

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.

This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in the residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation.

If the equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on, the
user is encouraged to try to correct the interference
by one of the following measures:

• Increase the separation between the equipment

and the affected receiver.

• Connect the equipment into an outlet on a circuit

different from the one the receiver is on.

Consult the dealer or an experienced radio/TV
technician for help.

3

IMPORTANT SAFETY INSTRUCTIONS

Changes or modification not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.

Declaration of Conformity

According to 47 CFR, Parts 2 and 15 for Class B
Personal Computers and Peripherals, and/or CPU
Boards and Power Supplies used with Class B
Personal Computers, Motorola, Inc., 101 Tournament
Drive, Horsham PA, 1-215-323-1000, declares under
sole responsibility that the product complies with 47
CFR Parts 2 and 15 of the FCC Rules as a Class B
digital device. Each product marketed is identical to
the representative unit tested and found to be
compliant with the standards. Records maintained
continue to reflect the equipment being produced and
can be expected to be within the variation accepted,
due to quantity production and testing on a statistical
basis as required by 47 CFR 2.909. Operation is
subject to the following condition: This device must
accept any interference received, including
interference that may cause undesired operation. The
above-named party is responsible for ensuring that

4

the equipment complies with the standards of 47
CFR, Paragraphs 15.107 to 15.109.

Canadian Compliance

This Class B digital device complies with Canadian
ICES-003.