
Important Safety Precautions
A Note From the Head Monster
Changing Speaker Side Panels
Connecting Your StreamLine Speaker
Connecting Your StreamLine THX Subwoofer

Please read and observe the following safety points at all times.
Ensure that your amplifier and receiver is switched off before connecting the speakers.
Make sure that you have connected the plus (+) and minus (–) terminals of each speaker to the
corresponding plus (+) and minus (–) terminals on the amplifier or receiver.
Before connecting the subwoofer to a power outlet, make sure that the operating voltage of your local
power supply is identical to that specified for the subwoofer (
Ensure the subwoofer is off before connecting the input signal cable on its internal amplifier.
Make sure that all screws on the binding posts are snug, especially if you are using bare speaker wires.
Contact between bare speaker wires may cause short-circuit and can potentially damage your equipment.
Continuously driving a low power amplifier at high power levels can cause distortion of the signal,
amplifier clipping and may cause severe damage to your speakers. High power amplifiers will deliver
Do not drive speaker units with a continuous wattage exceeding the maximum power indicated in this
instruction manual for each speaker model.
For the best performance possible use the high quality speaker and interconnect cables.
Do not place loudspeakers in dusty or humid environments.
Avoid exposure to direct sunlight.
00 speakers come with electronically protected tweeters to avoid overheating problems that can
cause damage. However for even greater protection, avoid extremely high volumes in your amplifier that can distort
audio signals or cause severe damage to your amplifier and your speakers.
IMPORTANT SAFETY P RECAUTIONS

A Note from the Head Monster
speakers. With these speakers you will enjoy many
the same thrilling experience I enjoy at the movie theater or at a live concert.
At Monster, we take pride in our commitment to making home audio the best it can be. Listen for yourself.
speakers, you can build a home theater audio system that meets your budget
while giving you the superior performance you desire.
This owner’s manual shows you how to properly position and hook up your new speakers for the best
Speakers and that you’ll have many years
A NO TE FRO M THE HEAD MONS TER

Your StreamLine subwoofer uses THX technology for superior low frequency response.
The StreamLine THX subwoofer supports flat anechoic response from 35Hz to 200Hz and accurate in-room response
Absolutely flat frequency response
Wide horizontal dispersion for full and flat frequency response throughout the entire room
*StreamLine is not a THX certified Product.
THX is a trademark or registered trademark of THX Ltd. All rights reserved.
INTRODUCTION
ASSEMBLY OF SPEA KER BASE

Technical Specifications:
CHANGING SPEAKER S IDE PANELS

terminal of the amplifier. Similarly, the negative speaker terminal (marked - and colored black) should be connected
to the negative amplifier terminal. Incorrect connection can result in poor sound imaging and reduced bass output.
Use the front right and left speaker output terminals on your
Use the two “surround” speaker output terminals on your receiver to connect
SPEAKER CONNECTION

VAR position if you do not. The VAR position offers independent control of the subwoofer’s volume through
the knob on the rear of the subwoofer.
In many systems, delay calibration is measured in meters, not feet from the hearing position.
Adjust the crossover frequency between
The adjustment of crossover frequency takes place through a technique called bi-amplification in which
the lower frequencies are being amplified exclusively by the subwoofer’s built-in amplifier. This improves
the frequency response of a home theater audio system, lowers the signal distortion, and increases
To properly meet the requirements of a THX Select certified subwoofer system, two Streamline subwoofers must
Turn your home theater system OFF.
for optimum audio performance.
OPERATION BETWEEN AV REC EIVE RS & YOUR S MART THX SUBWOOFERS

The sound field generated by a multichannel home theater audio system surrounds the audience, creating a three
to get the maximum accuracy and fidelity you should follow a careful set-up procedure.
when fed an identical signal.
that sound from all speakers arrives at the listener’s ears at the same time.
POSITIONING YOUR S MART S PEAK ER

when sitting at the listening position.
frequencies, move them towards the center of the room.
Video screen: Place your center speaker directly above or below your video screen, wherever is closest
Your StreamLine tower speakers can also be used for the surround channels.
POSITIONING YOUR S MART S PEAK ER

Wall Mounting of StreamLine Speakers
POSITIONING YOUR S MART S PEAK ER

Vérifiez que votre amplificateur ou récepteur est éteint avant de brancher les enceintes.
Veillez à brancher les bornes plus (+) et moins (–) de chaque enceinte aux bornes plus (+) et moins (–)
Avant de brancher le subwoofer à une prise électrique, assurez-vous que la tension de fonctionnement
Veillez à ce que le subwoofer soit hors tension avant de brancher le câble de signal d’entrée sur son
Assurez-vous que toutes les vis des bornes sont bien ajustées, surtout si vous utilisez des câbles pour
vos enceintes. Des amplificateurs haute puissance délivreront de meilleures performances.
CONSIGNES DE S ÉCUR ITÉ IMPORTANTES

d’avoir acheté les enceintes Monste
MESSAGE DU M ONST RE EN CHEF

Votre subwoofer StreamLine utilise la technologie THX pour d’excellentes réponses en basse fréquence.
Autres caractéristiques StreamLine :
Traitement haute puissance 200 WRms Max/200Hz pour un fonctionnement sûr avec de puissants
*StreamLine n’est pas un produit certifié THX.
THX est une marque commerciale ou déposée de THX Ltd. Tous droits réservés.
INTRODUCTION
MONTAGE DU S OCLE DES ENCEINTES

Assurez-vous que les panneaux sont solidement fixés au bâti des enceintes pour éviter toute vibration indésirable
CHANGEMENT DES P AN NEAUX LATÉ RAUX DES ENCEINTES

Veillez à ce que la borne positive de l’enceinte (marquée + et de couleur rouge) soit branchée à la borne de sortie
Assurez-vous de bien choisir les bornes d’enceintes de sortie correctes sur votre récepteur pour brancher
Utilisez les bornes de sortie d’enceintes avant droite
Utilisez les deux bornes de sortie d’enceintes « surround » sur votre
BRANCHEMENT DES EN CEINTES

Dans de nombreux systèmes, l’étalonnage de la temporisation est mesuré en mètres, et non
fréquence de croisement sur
FONCTIONNEMENT ENTRE LES R ÉCEP TEUR S AV ET V OTRE SUBWOOFER THX IN TELLIGENT

Enceinte avant
Enceinte gauche Enceinte droite
Enceinte Surround
gauche
Enceinte Surround
droite
Subwoofer THX
POSITIONNEMENT DE VOS ENCEIN TES INTELLIGENTES

vidéo, à l’endroit le plus proche du niveau de vos oreilles.
Vos enceintes colonnes StreamLine peuvent également être utilisées pour les canaux surround.
POSITIONNEMENT DE VOS ENCEIN TES INTELLIGENTES
POSITIONNEMENT DE VOS ENCEIN TES INTELLIGENTES