Mitsubishi Electronics QJ71E71-B5, QJ71E71-100, QJ71E71, QJ71E71-B2 User Manual
Series HMI Connection Manual
Mitsubishi Q Series Ethernet
（Supports QJ71E71 / QJ71E71-B2 / QJ71E71-B5 / QJ71E71-100 Series Module）
HMI Factory Setting:
Baud rate: 192.168.0.1
Controller Station Number: 1025
Control Area / Status Area: D0 / D10
Connection
Standard jumper Cable/ Network Cable without jumper (Auto-detected by HMI)
Definition of PLC Read/Write Address
a. Registers
Type
Input Xn X0 – X1FF0 Word Hexadecimal,
Output Yn Y0 – Y1FF0 Word Hexadecimal,
Internal Relay Mn M0 – M8176 Word 2
Special Internal Relay Mn M9000 – M9240 Word 3
Link Relay Bn B0 – B1FF0 Word Hexadecimal,
Annunciator Fn F0 – F2032 Word 2
Timer Value TNn TN0 – TN2047 Word
Counter Value CNn CN0 – CN2047 Word
Data Register Dn D0 – D8191 Word
Format
Read/Write Range Data Length Note
Word No. (n)
2
2
2
Special Data Register Dn D9000 – D9255 Word
Link Register Wn W0 – W1FFF Word Hexadecimal
b. Contacts
Type
Input Xb X0 – X1FFF Hexadecimal
134 V1.01 Revision November, 2011
Format
Read/Write Range Note
Bit No. (b)
Series HMI Connection Manual
Output Yb Y0 – Y1FFF Hexadecimal
Internal Relay Mb M0 – M8191
Special Internal Relay Mb M9000 – M9255
Format
Type
Read/Write Range Note
Bit No. (b)
Link Relay Bb B0 – B1FFF Hexadecimal
Annunciator Fb F0 – F2047
Timer Contact TSb TS0 – TS2047
Timer Coil TCb TC0 – TC2047
Counter Contact CSb CS0 – CS2047
Counter Coil CCb CC0 – CC2047
NOTE
1) Before using this communication protocol, the user needs to set communication module
via GX Developer programming tools. For more detailed information regarding the
setting method, please refers to Mitsubishi PLC User Manual.
2) The device address must be the multiple of 16.
3) The device address must be the multiple of 16 plus 9000.
V1.01 Revision November, 2011 135
Loading...