Mitsubishi MF-156DF-T12-201, MF-156DS-R13-171, MF-156DS-R13-172, MF-156DF-T12-292, MF-156DF-T12-231 Datasheet
...
MF-156DF-T12-20x/29x/23x
MF-156DS-R13-17x
DESCRIPTION
This product is designed to provide high optical
performance for SDH STM-1/SONET OC-3.
Transmitter uses uncooled laser in a hermetic pigtail
coaxial module with drivered by specific integrated
circuit.
Receiver uses PIN preamp in a hermetic pigtail
coaxial module and integrated circuits for reshaping,
retiming and regenerating optical signal.
FEATURES
SONET,SDH system from intra-office to longleach application fully line up
Low cost and Low power consumption
Multisourced 20-Pin DIP with pigtail fiber
Single +5V power supply and P-ECL compatible
input and output
Operating case temperature range -40 to 85°C
With clock recovery and digital alarm function
MITSUBISHI (OPTICAL DEVICES)
SONET/SDH TRANSMITTER & RECIEVER
APPLICATION
Short haul and long haul telecommunication systems
for SDH STM-1 / SONET OC-3.
ABSOLUTE MAXIMUM RATINGS
Stress below listed absolute maximum rating may cause permanent damage to the module.
This is a stress o nly and f unctional operat ion of t he m odule at t hese or any ot her c onditions in excess of t hose
given in the operational sections of this data sheet.
Exposure to Absolute Maximum Rating for extended periods may affect module reliability.
(T
Parameters Symbol Ratings Unit
Supply voltage Vcc +6 to 0 V
PECL high output current - -50 to 0 mA
PECL input voltage - 0 to Vcc+0.4 V
Storage temperature Tstg -40 to 85
Operating case temperature Tc -40 to 85
Soldering Temperature - +260
Soldering Time - 10 sec
Relative humidity(non condensation) - 10 to 80 %
Fiber bend radius from package rF 32 mm
C=25°C)
C
°
C
°
C
°
MITSUBISHI (OPTICAL DEVICES)
MF-156DF-T12-20x/29x/23x
MF-156DS-R13-17x
SONET/SDH TRANSMITTER & RECIEVER
ELECTRICAL CHARACTERISTICS
All parameters are specified over the operating case temperature.
Measurement conditions are at 155.52Mb/s+/-20ppm, NRZ PN2
The DATA input/output and CLOCK output signal levels are PECL compatible.
The transmitter disable input signal level is CMOS/TTL compatible.
The Signal Detect output signal level is PECL level compatible.
Transmitter
Parameters Condition Symbol Min. Typ. Max. Unit
Supply voltage - Vcc 4.75 5.0 5.25 V
Power consumption - Pc - 0.5 1.3 W
PECL input voltage note 1 - PECL Transmitter Disable voltage note 2 Vd Vcc-2.0V - Vcc V
Transmitter Enable voltage note 2 Ve 0 - 0.8 V
Laser bias monitor voltage note 3 Vb 0.01 - 0.45 V
Laser backface monitor voltage note 3 Vbf 0.01 - 0.20 V
23
-1 and 50% duty cycle data signal.
Receiver
Parameters Condition Symbol Min. Typ. Max. Unit
Supply voltage - Vcc 4.75 5.0 5.25 V
Power consumption - Pc - 1.0 1.5 W
PECL input voltage note 4,5 - PECL Data/Clock external Load note 4 RI 50 ohm
Data to clock phase note 6 Tcda -800 - 800 psec.
Clock duty note 6 - 45 - 55 %
Jitter - - ITU Rec.compliant -
Signal Detect Response Time:
Decreasing Light Input
Signal Detect Response Time:
Increasing Light Input
Photo Bias Current Responsity note 8 PBr 0.6 - - A/W
note 5,7 SDRTd - - 100 us
note 5,7 SDRTi - - 100 us
OPTICAL CHARACTERISTICS
Parameter Specification Unit
ITU code S-1.1 L-1.1 L-1.2
Optical Budget 0 14 0 29 0 30 dB
Transmitter
Wavelength 1261 1360 1280 1335 1480 1580 nm
Optical source MLM SLM(MLM) SLM Optical power at pigtail -14 -8 -5 0 -4 0 dBm
Optical power when disable - -45 - -45 - -45 dBm
Spectral width(rms) - 4 - -(4) - - nm
Spectral width(-20dB) - - - 1(-) - 1 nm
SMSR - - 30(-) - 30 - dB
Extinction ratio 8.2 - 10 - 10 - dB
Optical wave form SONET/SDH Mask compliant -
Path penalty
(dispersion = ITU-T compliant)
Receiver
Wavelength 1260 - 1580 nm
Sensitivity - -36 -34 dBm
Overload 0 +1 - dBm
MITSUBISHI (OPTICAL DEVICES)
MF-156DF-T12-20x/29x/23x
MF-156DS-R13-17x
SONET/SDH TRANSMITTER & RECIEVER
Min. Max. Min. Max. Min. Max.
-1-1-1dB
Min. Typ. Max.
ORDERING INFORMATION
Transmitter
Part number ITU-code Optical connector type
MF-156DF-T12-200 S-1.1 FC
MF-156DF-T12-201 S-1.1 SC
MF-156DF-T12-202 S-1.1 ST
MF-156DF-T12-290 L-1.1 FC
MF-156DF-T12-291 L-1.1 SC
MF-156DF-T12-292 L-1.1 ST
MF-156DF-T12-230 L-1.2 FC
MF-156DF-T12-231 L-1.2 SC
MF-156DF-T12-232 L-1.2 ST
Receiver
Part number ITU-code Optical connector type
MF-156DS-R13-170 STM-1 FC
MF-156DS-R13-171 STM-1 SC
MF-156DS-R13-172 STM-1 ST
Loading...