Minoura Japan Headquarters Minoura North American Center
1197-1 Godo, Anpachi, Gifu 503-2305 Japan (for U.S. residents only)
Phone: +81-584-27-3131 / Fax: +81-584-27-7505 1996 East Avenue, Hayward, CA 94541-5454 U.S.A.
Email: minoura@minoura.jp / URL: www.minoura.jp Phone: 1-510-538-8599 / Fax: 1-510-538-5899
Email: support@minourausa.com
Made in Japan
INDOOR BICYCLE TRAINER
IMPORTANT NOTES
• Read all instructions carefully before use.
• Some assembly required. Use correct tools.
• Keep the manual handy at all times.
• Do NOT use trainer for any purpose other than instructed.
• The trainer is manufactured to precise standards. Disassembling or rebuilding by
yourself will void the warranty.
WARNINGS
●
Use two-wheeled bicycles only. Tandems may be used if balanced correctly.
●
Minoura strongly suggests you use the supplied Quick Release skewer (for those bicycles
that use Q/R systems) and coupling protector cap to insure a secure t of your bicycle to
the trainer frame. If your bicycle has a xed axle nut system you cannot use the supplied
q/r and must make sure that the axle nuts ts securely into the couplings. If they do not t
evenly and securely, our trainer is not compatible with your bicycle and Minoura assumes no
responsibility for such use.
●
Remove all oils and moisture from the drive roller and the tire before use.
●
Keep both hands on handlebar at all times and maintain a normal riding position.
●
Check the couplings supporting the rear hub for damage and cracks. Accidents may occur
from cracked or damaged couplings.
●
You should not tighten the wheel axle by tightening the left side knob. This is for pre-
adjusting the wheel position to the exactly center of the drive roller only. Holding the wheel
securely must be done by the right side hub handle.
●
When using the trainer, place it on a at and level surface for safe training.
●
Do not over-tighten the hub handles. Overtightening may cause damage to the trainer or
your bicycle frame. The clamp handles should be a snug and secure t. Do NOT force!
●
Before use, make sure all bolts and nuts are securely fastened.
●
Keep away from small children, and keep hands and feet away from spinning rollers and
wheels at all times.
●
Tighten the pivot bolts on the main frame rmly before installing your bike.
!
●
The VFS resistance unit becomes very HOT while using. Do NOT touch the VFS unit during
use or for 30 minutes after use.
- 2 -
VFS-G (without remote shifter)
VFS-G-R (with remote shifter)
Fluid Unit
Fluid Unit
VFS-G Frame
35mm Rubber
Foot Cap
Sub Frame
Sub Frame Back Plate
Hub Handle
Protector Cap
Coupling Cover
Hub Knob
Bolt
Coupling Tube (R)
Coupling Tube (L)
Unit Base
Mount Base
Pad
Pad Cover
Base Bracket
Inner Housing
Magnet
Outer Housing
Remote Shifter
Remote Bracket
Spring
Inner Housing
Magnet
Alloy Rotor
Flywheel
Flywheel Cover
Coupling Cover
Remote Ring
Remote Cover
Remote Cable
M8x20 Bolt
M8x15 Bolt
M8x70 Bolt
Loading...