Minoura VERGO User Manual

VERGO instruction manual

Thank you for purchasing the “VERGO” bike mount kit.

You can hold two or three bikes in the cargo space of your vehicle or on the truck bed easily and

with stability.

Please read the following instructions carefully before use.

HOW TO USE VERGO

Place VERGO on a flat floor of the cargo space.

1.

VERGO itself is free standing so uneven

floor design will compromise stability.

Remove the front wheel, then clamp the front

2.

fork on the Fork Mount with the supplied

quick release skewer.

When you need to adjust the bikes position, just

3.

slide the Fork Mount by loosening the knob

bolt and moving the mount in either direction.

Slide to the desired position, then tighten the knob

bolt firmly to fix the position.

Make sure both adjustment position guides are

properly in the rail of the main frame.

The Fork Mount can be twisted in 25 degrees in

4.

both directions. This makes for easy adjustment

for handlebar issues and saves space.

<Mounting Example>

Two bikes in a mini-van

Twisted Fork Mount position

CAUTION

Understand: Bikes on VERGO are not attached to. If you drive hard, the bikes may move around
in your vehicle. To keep the bikes stable, we recommend tying bikes down with a long strap.

How To Disassemble and Assemble

VERGO is already assembled so you don’t need

to disassemble the kit. You may want to add

or replace optional Fork Mounts. To do so,

follow the steps.

Remove the two screws under the End

1.

Cover with a phillips screwdriver, then the

End Cover will be removed.

End Cover

Base Plate

Fork Mount

Knob Bolt

Guide Plate

Disassemble the Fork Mount. It’s simple,

2.

just remove the knob bolt.

Insert the Base Plate into the Base Frame.

3.

Be sure the direction of the Base Plate must be “M” style, not “W” style.

Place the Guide Plate onto the Base Frame and confirm both adjustment position guides

4.

on the back side are properly fitted to the Rail. The guide will be flush with the base frame.

Place the Fork Mount on the Guide Plate then tighten the Knob Bolt.

5.

Finally, insert the End Cover to the Base Frame and tighten the screws.

6.

Rail

Screw & Washer

OPTION

The “DH Fork Mount” for 20mm axle is available as an option.

Base Frame

More Information

Contact: MINOURA JAPAN HEAD OFFICE

1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Phone [phone] / Fax [phone]
Email : [e-mail] / http://www.minoura.jp

MINOURA NORTH AMERICAN CENTER

1996 East Avenue, Hayward, CA 94541-5454 U.S.A.
Phone [phone] / Fax [phone]
Email : [e-mail]

MADE IN JAPAN

DH Fork Mount
for 20mm axle