Minolta 5440, 5450, 5430 User Manual

MINOLTA

®

MAGICOLOR 5430 • 5440 • 5450

CARTRIDGE REMANUFACTURING INSTRUCTIONS

© 2007 UniNet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not guarantee or warrant downloaded information.

www.uninetimaging.com/technical.asp

11124 Washington Blvd., Culver City, California USA 90232 • Ph [phone] • Fx [phone] • [e-mail]

Absolute COLOR

®

• Absolute BLACK®• Unidrums®• Unirollers®• Uniparts®• Unicoatings

®

MINOLTA®MAGICOLOR 5430

COLOR LASER PRINTER WITH TONER CARTRIDGE

UNINET IMAGING INC. • MINOLTA

®

MAGICOLOR 5430 CARTRIDGE REMANUFACTURING INSTRUCTIONS

MINOLTA®MAGICOLOR 5430 TONER CARTRIDGE

SIDE VIEW WITH END CAP SHOWN

BACK VIEW OPPOSITE SIDE VIEW

© 2007 UniNet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not guarantee or warrant downloaded information.

www.uninetimaging.com/technical.asp

11124 Washington Blvd., Culver City, California USA 90232 • Ph [phone] • Fx [phone] • [e-mail]

UNINET IMAGING INC. • MINOLTA

®

MAGICOLOR 5430 CARTRIDGE REMANUFACTURING INSTRUCTIONS

SEPARATING THE CARTRIDGE

1. Locate the cartridge end cap of the cartridge.

Using a phillips screwdriver, remove the seven highlighted
screws that hold the cartridge together.

2. Cartridge separated. Set the drum unit and end cap aside.

We will now proceed to clean the toner hopper.

CLEANING THE TONER HOPPER

3. Locate the toner hopper fill plug.

4. Using a small flathead screwdriver, carefully remove the fill
plug by prying it off.

Empty any residual toner from the hopper and clean thoroughly
using compressed air.

Once clean, refill, apply plug, and set aside.

© 2007 UniNet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not guarantee or warrant downloaded information.

www.uninetimaging.com/technical.asp

11124 Washington Blvd., Culver City, California USA 90232 • Ph [phone] • Fx [phone] • [e-mail]

UNINET IMAGING INC. • MINOLTA

®

MAGICOLOR 5430 CARTRIDGE REMANUFACTURING INSTRUCTIONS

SEPARATING THE DRUM UNIT

5. The drum unit (top) and developer unit (bottom) are joined
together.

6. Locate the gear train side of the drum unit.

Remove the OPC contact (highlighted).

Now remove the gear train directly behind it. Note the position­ing of the gears. One of the gears is not removable.

7. After removing he gears, release the two screws that hold the
drum axle plate in place.

Release the compression spring that is connected to the devel­oper unit beneath.

Slide the drum axle plate out.

8. Drum axle plate removed.

© 2007 UniNet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not guarantee or warrant downloaded information.

www.uninetimaging.com/technical.asp

11124 Washington Blvd., Culver City, California USA 90232 • Ph [phone] • Fx [phone] • [e-mail]