Microlab T-9752 U, T-9752 V Instruction Manual

Instruction Manual

T-9752 U 16-Channel UHF FM Transceiver400-470MHz
T-9752 V 16-Channel VHF FM Transceiver130-174MHz

SAFETY INFORMATION

Your wireless handheld portable transceiver contains a low power transmitter. When the Push-To-Talk (PTT) button is pressed, it

sends out radio frequency signals. The device is authorized to operate at a duty factor not to exceed fifty percent.

CAUTION

To maintain compliance with the FCC s RF exposure guidelines, hold the transmitter and antenna at least two inches from your

face and speak in a normal voice, with the antenna pointed up and away from your face. If you wear t he handset o n your body

while using the headset accessory, use only the supplied belt clip for this product. When transmitting, take it out of the belt to

ensure the antenna is at least one inch (2.5cm) from your body. Use only the supplied antenna. Unauthorized antennas,

modifications, or attachments could damage the transmitter and may violate FCC regulations.

We are grateful for your purchase of this microlab transceiver .We believe this easy-to-use transceiver will provide you
with dependable and reliable communications.

Microlab We adopt advanced technology & workmanship for this transceiver,we trust our aborative design will make it
better &quicker service for you ;for correct usr ,please read this manusl before use.

MODELS COVERED BY THIS MANUAL
T-9752 U 16-Channel UHF FM Transceiver400-470MHz
T-9752 V 16-Channel VHF FM Transceiver130-174MHz

PRECAUTIONS
Refer service to qualified technicians only.
Do not operate the transceiver or charge a battery packin an explosive atmosphere(gases,dust,fumes,etc.)
Turn OFF the transceiver while taking on fuel or while parked in a gasoline service station.
Do not modify or attempt to adjust this transceiver for any reason .
Do not expose the transceiver to long periods lf direct sunlight,nor place it close to heating appliances
Do not place the transceiver in excessively dusty ,humid,and /or wet areas ,nor on unstable surfaces.

SAFETY:It is important that the operator is aware of ,and understands,hazards common to the operation of any

transceiver.

THANK YOU

1

1
2
2
4
5
5
5
5
6
7
8

8
8

8

8

8

9
9

10

UNPACKING AND CHECKING EQUIPMENT
Supplied Accessories
PREPARATION
Charging the Ni-MH Battery pack
Installing/Removing the Battery Pack
Installing the Antenna
Installing the Belt Clip
Installing the Cover over the speaker/Microphone jacks
Installing the Optional Speaker/Microphone
GETTING ACQUAINTED T-9752
T-9752 OPERATION
AUXILIARY FUNCTIONS
Time-out Timer
Battery Save
Low Battery Warning
Monitor
Quiet Talk (QT) and Digital Quiet Talk (DQT)
OPTIONAL ACCESSORIES
TROUBLESHOOTING GUIDE
FREQUENCY CHART

CONTENTS