Metro Power Strip Cord Wrap Mounted on Overbridge User Manual

X

Power Strip / Cord Wrap

INSTALLATION

Mounted on Overbridge

INSTRUCTIONS

PART # SX595

Assembly consists of (1) Hospital Grade, 6 outlet, 15-ft Power Strip, (1) Cord Wrap,

(1) Hardware Bag

1. Both the OVERBRIDGE AND THE POWER STRIP must be installed as ONE ASSEMBLY

onto the Starsys cart. Both the power strip and overbridge instructions must be used.

2. On the rear of the power strip, place #6-32 x 1/2 screws in cross-slots. Insert screws into

the holes on the cord wrap’s long plate. Secure with (2) #6-32 nuts. Power strip is now
anchored to the cord wrap.

3. Determine which rear corner the power strip/ cord wrap is to be located. On the matching

overbridge support leg, align holes in cord wrap and support leg. Distance will be 21”.

4. Take the (2) #8-32 x 2” screws (supplied in the power strip hardware bag) and insert them

through cord wrap and overbridge leg. As detailed in the overbridge instructions, place
spacers and cam nuts on to #8-32x 2” screws. Do not tighten. Assemble the screws,
spacers and cam nuts (supplied with overbridge) into the other overbridge support leg.

5. Place the overbridge/ power strip against the rear of the cart, Aligning cam nuts with

cutouts in filler strips. Insert cam nuts into the post slots and tighten. Make sure cam nuts
lock into the post slot. Loop cord around wrap.

Power Strip

X 2

Cord Wrap

Plastic Post
Filler Strip

o

Cut outs for
cam nuts

Overbridge
Support

o

21”

Cam Nut

2/ Side

Raise circle on nut to
face towards screw

New #8-32 x 2” Screws in

Power Strip Hardware bag

X 2

Spacer

X 2 / Side

Rear of Starsys

Power Strip / Cord Wrap

INSTALLATION

INSTRUCTIONS

PART # SX595

Assembly consists of (1) Hospital Grade, 6 outlet, 15-ft Power Strip, (1) Cord Wrap,

(2) Hardware Bag

1. On the rear of the power strip place (2) #6-32 x 3/8 screws into the keyhole slots, trapping the heads in the

slots.

2. Place power strip against the long plate on the cord wrap inserting the screws through the mounting holes.

Secure with (2) #6-32 nuts.

3. In the holes on the cord wrap short plates, insert (2) #8-32x ¼ screws and start (2) cam nuts onto screws. The

raised circle on the cam nuts must face toward the screw. Leave loose.

4. The power strip/ cord wrap assembly can be mounted on either rear corner of the Starsys unit, however, one

corner will have the post filler strip removed at the factory for mounting. Determine the mounting height
location on the post and mark the cut locations on the filler strip. Two (2) 1” long sections must be cut out of
the filler strip in order for the cam nuts to be inserted into the post slot per the illustration below. Use a sharp
utility knife to score the sections, then snap them in half.

5. Insert cam nuts into the post slots and tighten. Make sure cam nuts lock into the post slot.

6. Insert the post filler strip sections into the post slot by pressing firmly and snapping them into place.

7. Loop cord around wrap.

Power Strip

X 2

Cord Wrap

X 2

Plastic Post
Filler Strip

Cut outs for
cam nuts

21”

Cam Nut

X 2

X 2

Rear of Starsys

Raise circle on nut to
face towards screw

INST-SX595
Rev. 4/04