Mercedes-Benz CRADLE ADAPTOR Installation Manual

Accessories
Installation Instructions
Mercedes-Benz Cradle adaptor with
Bluetooth
®
wireless technology
© 2007, Daimler AG
1
M+P-03F-6311
1
The Mercedes-Benz approved/recom­mended Bluetooth
®
Phones can be
utilized inside Mercedes-Benz vehicles.
Application
These installation instructions are valid for vehicles with an MHI hands-free communi­cations systems and a Mercedes-Benz-ap­proved Bluetooth
®
mobile telephone. Approved mobile telephones are listed and can be purchased on the Internet at www.wireless4mb.com or call 1-800-266­7746 to speak to a wireless activation specialist.
Parts included
• (1) Mercedes-Benz Cradle adaptor
with Bluetooth
®
wireless
technology
Notes
Please contact your local Mercedes-Benz Center if you encounter difficulties when operating the Mercedes-Benz Hands-Free Communication System.
More information can be found on the Internet at www.wireless4mb.com or call 1-800-266-7746 to speak to a wireless activation specialist.
GWarning
It is not recommended to operate the mobile telephone keypad while driving.
2
Contents
Installing the Mercedes-Benz Cradle adaptor with Bluetooth
®
3
Pairing the mobile telephone with the Mercedes-Benz Cradle adaptor with Bluetooth
®
4
Establishing a Bluetooth
®
Connection
6
Connecting the mobile telepho­ne and Mercedes-Benz Cradle adaptor with Bluetooth
®
manually
8
Disconnecting the Bluetooth
®
connection automatically
9
Disconnecting the Bluetooth
®
-
connection manually
9
Detaching the Mercedes-Benz Cradle adaptor with Bluetooth
®
10
3
Notes
The manufacturer reserves the right to change technical details from those shown in the illustrations contained in these installation instructions.
These installation instructions also refer to the vehicle Operator's Manual, COMAND Operator's Manual, and mobile telephone manual. Please refer to them for reference.
Use of a mobile telephone other than a Mercedes-Benz approved/recommended model may result in improper performance and cannot be equipped or serviced by Mercedes-Benz.
Installing the Mercedes-Benz Cradle adaptor with Bluetooth
®
Insert the Mercedes-Benz Cradle adaptor with Bluetooth
®
(1) into the latches on the pre-installed contact plate (2), located in the center console. To insert the Mercedes-Benz Cradle adaptor with Bluetooth
®
(1), slide it
upwards until it clicks into place.
2
1
M+P-03F-6312
4
Pairing the mobile telephone with the Mercedes-Benz Cradle adaptor with Bluetooth
®
Make sure that the starter switch is in position 1, 2 or 3 (see the vehicle Operator's Manual).
1. With Mercedes-Benz Cradle adaptor with Bluetooth
®
connected to the vehicle
press button (3) for approx. 2-3 seconds.
The LED’s (4) will begin to flash rapidly. The Mercedes-Benz Cradle adaptor with Blue­tooth
®
is in Discovery Mode and can be
detected by a Bluetooth
®
mobile telephone. The Mercedes-Benz Cradle adaptor with Bluetooth
®
will appear as "MB PhoneSys-
tem" on the mobile telephone.
2. For instructions on how to get the mobile telephone ready for pairing, see the mobile telephone manual or visit www.wireless4mb.com. Once the mobile telephone and Mercedes-Benz Cradle adap­tor with Bluetooth
®
find each other the mobile telephone will prompt the user to enter a Pass-Key.
3
4
M+P-03F-6313
5
3. To locate the Pass-Key remove cover (5) by sliding it away from the Mercedes-Benz Cradle adaptor with Bluetooth
®
. Located behind this cover (5) there will be a sticker containing the Pass-Key (6).
4. When prompted, enter the Pass-Key into the mobile telephone. Depending on the type of mobile telephone being used, it may be necessary to confirm a connection request (see the mobile telephone manual).
5. Once the Pass-Key has been entered and accepted the LED’s (4) will be lit conti­nuously. This confirms that the mobile tele­phone is paired and connected and the mobile telephone information has been stored in the Mercedes-Benz Cradle adaptor with Bluetooth
®
.
6. The mobile telephone is now ready for use with the Mercedes-Benz Hands-Free Communication System.
5
6
M+P-03F-6379
6
Establishing a Bluetooth
®
Connection
Notes
A maximum of 4 mobile telephones can be paired with the Mercedes-Benz Cradle adap­tor with Bluetooth
®
. However, only one mo­bile telephone is connected to the Mercedes-Benz Cradle adaptor with Blue­tooth
®
at a time. If a fifth mobile telephone is paired with the Mercedes-Benz Cradle ad­aptor with Bluetooth
®
, then the information stored from the first mobile telephone which was paired with the Mercedes-Benz Cradle adaptor with Bluetooth
®
will be replaced.
When the starter switch is in position 1, 2 or 3 (see the vehicle Operator's Manual), the Mercedes-Benz Cradle adaptor with Blue­tooth
®
will search for the last connected
mobile telephone and reconnect.
The Mercedes-Benz Cradle adaptor with Bluetooth® will automatically begin a continuous search for a previous paired mobile phone after startup.
If the last connected mobile telephone is not found the Mercedes-Benz Cradle adaptor with Bluetooth
®
will search for one of the
previously paired phones and connect to it.
If the connection between the Mercedes-Benz Cradle adaptor with Blue­tooth
®
and mobile telephone is not establis-
hed automatically, it is possible to establish a connection manually (see 컄 8).
7
Note
When using Bluetooth
®
the mobile telepho­ne uses more power. Since the mobile tele­phone is not being charged the battery should have a sufficient charge.
SMS messages can not be accessed via the COMAND or radio while the Bluetooth
®
connection is established.
Not every ring-tone of the mobile telephone is supported by the COMAND or radio.
3-way-calling and call waiting are not sup­ported from the Mercedes-Benz Cradle ad­aptor with Bluetooth
®
. An audible peep will
notify a waiting call.
The roaming indication is not supported by the COMAND or radio.
For a list of supported features please visit www.wireless4mb.com.
The Tele Aid System (emergency call sys­tem) will continue to function as designed as long as there is a valid service contract.
8
Connecting the mobile telephone and Mercedes-Benz Cradle adaptor with Blue­tooth
®
manually
Valid for all Mercedes-Benz vehicles with the exception of the model year 2007 S-Class:
• Press button on the COMAND or
radio.
Model year 2007 S-Class vehicles:
• Using the COMAND Controller, select
"Telephone" "Telephone" "Tele- phone on".
Note
Before manual connection, the mobile tele­phone must previously be paired with the Mercedes-Benz Cradle adaptor with Blue­tooth
®
(see pairing procedure 컄 4).
When the mobile telephone is within the ran­ge (approx. 30 ft) of the Mercedes-Benz Cradle adaptor with Bluetooth
®
, the connec­tion between the mobile telephone and the Mercedes-Benz Cradle adaptor with Blue­tooth
®
remains active, and phone calls made with the mobile telephone use the ve­hicle’s hands-free system. For this reason, the connection between the mobile telepho­ne and the Mercedes-Benz Cradle adaptor with Bluetooth
®
should be disconnected
manually if the mobile telephone is taken out of the vehicle (see 컄 9).
9
Disconnecting the Bluetooth® connec­tion automatically
The connection between the Mercedes-Benz Cradle adaptor with Bluetooth
®
and the mobile telephone is automatically discon­nected when the mobile telephone travels outside of the range (approx. 30 ft) of the Mercedes-Benz Cradle adaptor with Blue­tooth
®
.
Disconnecting the Bluetooth
®
-connec-
tion manually
The connection between the mobile telepho­ne and the Mercedes-Benz Cradle adaptor with Bluetooth
®
can be disconnected at any time by using the mobile telephone (see the mobile telephone manual).
To disconnect the paired mobile telephone from Mercedes-Benz Cradle adaptor with Bluetooth
®
using the COMAND or radio. Valid for all Mercedes-Benz vehicles with the exception of the model year 2007 S-Class:
•Press and hold button on the
COMAND or radio for approx. 3 seconds.
Model year 2007 S-Class vehicles:
• Using the COMAND Controller, select
"Telephone" "Telephone" "Tele- phone off".
Note
If a phone call is in progress, the connection can only be disconnected directly on the mobile telephone (see the mobile telephone manual).
10
Detaching the Mercedes-Benz Cradle adaptor with Bluetooth
®
Press and hold the release button (7). Slide the Mercedes-Benz Cradle adaptor with Bluetooth
®
(1) in direction of arrow (8) and remove it from the pre-installed contact plate (2).
Note
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
• This device may not cause harmful inter-
ference.
• This device must accept any interfe-
rence received, including interference that may cause undesired operation.
1
8
7
2
M+P-03F-6314
Loading...