McQuay PDExx Installation Manual
SCREWS
COVER PLATE
COVER PLATE
TUBE
GASKET
DETAIL
1/2” (13mm)
O.D.
CABINET
BOTTOM
Suite II
™
Condensate Drain Kit
Installation & Maintenance Data
IM 430-3
Group: PTAC
Part No.: 106018601
Date: May 1999
Note: Heat pump models will generate condensate during
the heating season. To insure that no condensate will
rundown the building, always use a drain kit with the heat
pump. Condensate drain kits can be supplied for internal or ex-
ternal applications. Figure 1 illustrates the installation of the indoor drain kit. The indoor drain kit should be installed bef ore placing the cabinet wall sleeve into the opening. Install as follows:
Figure 1. Internal drain kit
Contractor To Drill
Three (3) Holes To
Accept Drain Kit
See Detail
Square Drain
Neoprene Sponge Gasket
Steel Mounting Plate
Assembly of the external drain kit should be completed after the
cabinet wall sleeve has been installed. Install the external drain
kit as follows:
1. Assemble the drain kit as shown in Figure 2.
2. Choose which side of the cabinet wall sleev e the drain kit is to
be installed.
Holes
1. Locate the drain so that it will be on the room side of the wall
when the cabinet wall sleeve is installed.
1
2. Drill a
/2 " (13mm) diameter hole in the base of the cabinet
wall sleeve for the drain line.
3. Drill two (2) 5/32" (4mm) pilot holes for the mounting screws.
These holes can be located using the drain kit as a pattern.
4. Assemble the drain kit as shown in Figure 1 and securely
fasten it to the cabinet wall sleeve with screws provided.
5. Slide the cabinet wall sleeve into the opening and anchor it
into place.
Room Side
3. There are weep holes and pilot holes provided in the cabinet
wall sleeve from the factory. Place the drain kit against the
chosen weep hole and fasten securely with screws pro vided.
4. Cover the unused weep holes with the b lockoff plate supplied
with the drain kit.
5. Discard the unused steel mounting plate and gasket.
Figure 2. External drain kit
Square Drain Holes
Neoprene Sponge Gasket
Steel Mounting Plate
AAF–McQuay Incorporated
4900 Technology Park Boulevard, Auburn, New York 13021-9030 USA (315) 253-2771
Printed on recycled paper containing at least 10% post-consumer recycled material.
©1999 AAF–McQuay Incorporated IM 430-3 (Rev. 5/99)
1
/2" (13mm) O.D. Drain Tube
Room Side
Loading...