McCulloch Li 58GBP operation manual

Li 58GBP

EN Operator's manual 2-14

BBP58VPR

Contents

INTRODUCTION............................................................ 2

SAFETY..........................................................................

ASSEMBLY.................................................................... 8

OPERATION...................................................................9

INTRODUCTION

MAINTENANCE............................................................11

3

TROUBLESHOOTING..................................................12

TECHNICAL DATA.......................................................13

CONTENTS OF THE EC DECLARATION OF

CONFORMITY..............................................................14

Operator's manual

The initial language of this operator's manual is English.
Operator's manuals in other languages are translations
from English.

1. Battery pack
Battery charger

2.

3. Battery status indicator button

4. Battery state of charge LED

5. Harness

6. Nozzle

7. Middle tube

8. Trigger

9. Upper tube

10. Tube clamp bolt

11. Flexible tube

12. Air intake

13. Fan housing

14. Electrical powerhead

15. Elbow

16. Control wire

17. Control wire clips

18. Digital control center

Overview

19. Power meter

20. Battery state of charge LED

21. Power boost button

22. Power button

23. Digital cruise control

24. Blower tube storage hook

25. Backpack handle

26. Battery release button

27. Screw

28. Rear cover

29. Lower cover

30. Operator's manual

Symbols on the product

Warning

2 449 - 003 - 20.11.2017

Read this manual.

Right hook

Use approved hearing protection

Use approved eye protection

Use approved dust mask

Use approved protective boots and gloves

Wear long sleeves and trousers

Look out for thrown objects and ricochets

Do not wear jewelry when you operate the
product

Safe distance

Keep hairs above shoulders

Tube rotate

Electrical shock

Guaranteed sound power level

The product or packaging cannot be
handled as domestic waste. The product
and packaging must be submitted to an
appropriate recycling station for the recovery
of electrical and electronic equipment.

Do not leave, store or use in the rain or in
wet conditions.

Recycle

Note: Other symbols/decals on the product refer to
certification requirements for other commercial areas.

Product liability

As referred to in the product liability laws, we are not
liable for damages that our product causes if:

• the product is incorrectly repaired.

• the product is repaired with parts that are not from
the manufacturer or not approved by the
manufacturer.

•

the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.

• the product is not repaired at an approved service
center or by an approved authority.

Left hook

SAFETY

Safety definitions

The definitions below give the level of severity for each
signal word.

449 - 003 - 20.11.2017 3

WARNING: Injury to persons.

CAUTION: Damage to the product.

Note: This information makes the product easier to use.

General power tool safety warnings

WARNING: Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions may result in electric shock,
fire and/or serious injury.

Save all warnings and instructions for future reference.

The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.

Work area safety

• Keep work area clean and well lit. Cluttered or dark
areas invite accidents.

• Do not operate power tools in explosive
atmospheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.

• Keep children and bystanders away while operating
a power tool. Distractions can cause you to lose
control.

Electrical safety

• Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any adapter
plugs with earthed (grounded) power tools.
Unmodified plugs and matching outlets will reduce
risk of electric shock.

• Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.

• Do not expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of
electric shock.

• Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool. Keep
cord away from heat, oil, sharp edges or moving
parts. Damaged or entangled cords increase the risk
of electric shock.

• When operating a power tool outdoors, use an
extension cord suitable for outdoor use.
cord suitable for outdoor use reduces the risk of
electric shock.

• If operating a power tool in a damp location is
unavoidable, use a ground fault circuit interrupter
(GFCI) protected supply. Use of a GFCI reduces the
risk of electric shock.

Personal safety

Use of a

• Stay alert, watch what you are doing and use
common sense when operating a power tool. Do not
use a power tool while you are tired or under the
influence of drugs, alcohol or medication. A moment
of inattention while operating power tools may result
in serious personal injury.

• Use personal protective equipment. Always wear
eye protection. Protective equipment such as dust
mask, non-skid safety shoes, hard hat, or hearing
protection used for appropriate conditions will reduce
personal injuries.

• Prevent unintentional starting. Ensure the switch is in
the off-position before connecting to power source
and/or battery pack, picking up or carrying the tool.
Carrying power tools with your finger on the switch
or energising power tools that have the switch on
invites accidents.

• Remove any adjusting key or wrench before turning
the power tool on. A wrench or a key left attached to
a rotating part of the power tool may result in
personal injury.

• Do not overreach. Keep proper footing and balance
at all times. This enables better control of the power
tool in unexpected situations.

• Dress properly. Do not wear loose clothing or
jewellery. Keep your hair, clothing and gloves away
from moving parts. Loose clothes, jewellery or long
hair can be caught in moving parts.

• If devices are provided for the connection of dust
extraction and collection facilities, ensure these are
connected and properly used.
can reduce dust-related hazards.

Power tool use and care

• Do not force the power tool. Use the correct power
tool for your application. The correct power tool will
do the job better and safer at the rate for which it
was designed.

• Do not use the power tool if the switch does not turn
it on and off. Any power tool that cannot be
controlled with the switch is dangerous and must be
repaired.

• Disconnect the plug from the power source and/or
the battery pack from the power tool before making
any adjustments, changing accessories, or storing
power tools. Such preventive safety measures
reduce the risk of starting the power tool
accidentally.

• Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained
users.

• Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool’s
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.

Use of dust collection

4 449 - 003 - 20.11.2017

• Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.

• Use the power tool, accessories and tool bits etc. in
accordance with these instructions, taking into
account the working conditions and the work to be
performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.

Battery tool use and care

• Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one type
of battery pack may create a risk of fire when used
with another battery pack.

• Use power tools only with specifically designated
battery packs. Use of any other battery packs may
create a risk of injury and fire.

• When battery pack is not in use, keep it away from
other metal objects, like paper clips, coins, keys,
nails, screws or other small metal objects, that can
make a connection from one terminal to another.
Shorting the battery terminals together may cause
burns or a fire.

• Under abusive conditions, liquid may be ejected from
the battery; avoid contact. If contact accidentally
occurs, flush with water. If liquid contacts eyes,
additionally seek medical help. Liquid ejected from
the battery may cause irritation or burns.

Service

• Have your power tool serviced by a qualified repair
person using only identical replacement parts.
will ensure that the safety of the power tool is
maintained.

This

General safety instructions

• Use the product correctly. Injury or death is a
possible result of incorrect use. Only use the product
for the tasks found in this manual. Do not use the
product for other tasks.

• Obey the instructions in this manual. Obey the safety
symbols and the safety instructions. If the operator
does not obey the instructions and the symbols,
injury, damage or death is a possible result.

• Do not discard this manual. Use the instructions to
assemble, to operate and to keep your product in
good condition. Use the instructions for correct
installation of attachments and accessories. Only
use approved attachments and accessories.

• Do not use a damaged product. Obey the
maintenance schedule. Only do the maintenance
work that you find an instruction about in this
manual. An approved service center must do all
other maintenance work.

• This manual cannot include all situations that can
occur when you use the product. Be careful and use
your common sense. Do not operate the product or
do maintenance to the product if you are not sure
about of the situation. Speak to a product expert,

your dealer, service agent or approved service
center for information.

• Remove the battery pack before you assemble the
product, put the product into storage or do
maintenance.

• Do not use the product if it is changed from its initial
specification. Do not change a part of the product
without approval from the manufacturer. Only use
parts that are approved by the manufacturer. Injury
or death is a possible result of incorrect
maintenance.

• Do not start the product indoors or near flammable
material.

• The motor makes an electromagnetic field when you
use the product. The electromagnetic field can cause
damage to medical implants. Speak to your
physician and medical implant manufacturer before
you operate the product.

• Do not let a child operate the product. Do not let a
person, without knowledge of the instructions
operate the product.

• Make sure that you always monitor a person, with
decreased physical capacity or mental capacity, that
uses the product. A responsible adult must always
be.

• Lock the product in an area that children and not
approved persons cannot access.

• The product can eject objects and cause injuries.
Obey the safety instructions to decrease the risk of
injury or death.

• Do not go away from the product when the motor is
on.

• The operator of the product is responsible if an
accident occurs.

• Make sure that parts are not damaged before you
use the product.

• Make sure that you are a safe distance away from
other persons or animals before you use the product.
Make sure that a person in adjacent area knows that
you will use the product.

• Refer to national or local laws. They can prevent or
decrease the operation of the product in some
conditions.

Safety instructions for operation

• Use the product only for the blowing or removal of
leaves and other unwanted material on the ground.

• Do not let bystanders or animals be less than 15 m
(50 ft) from the operator.

• This product can eject objects at high speed that can
ricochet in the direction of the operator. This can
cause eye damage.

• Examine the work area before you use the product.
Remove all unwanted material and hard objects,
such as rocks, glass and wire, that can be ejected,
ricochet, or cause injury or damage during operation.

• Do not point the blower nozzle in the direction of
persons, animals, open windows or vehicles.

449 - 003 - 20.11.2017 5