Maytag YMED9000YW0, YMED9000YR0, YMED9000YG0, YMED7000XW0, YMED7000XW1 Installation Guide

DOOR RB R$$ T

TROUS POUR U[ RS[ON DE LA PORTE

DRYER S_ET¥

Your safety and the safety of others are very important,

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.

This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:

You can be killed or seriously injuredifyou don't immediately
follow instructions.

You can be killedorseriously injuredif you don't follow

instructions,

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can

happen if the instructions are not followed.

TOOLS .&NDPARTS INST_L_TION INSTRUCTIONS

Tools and Parts
Gather required tools and parts before starting installation.

Tools needed:

Min. 8" long Torx®tT25
screwdriver

Parts included:

Cover strip

#2 Phillips screwdriver

Using a Torx®t T25 screwdriver, remove the 4 screws securing
the door hinge to the dryer and lift up and out to remove the

door. Place the door on a soft towel or other non-scratch
surface. Reinstall the 4 screws.

1-® TORX is a registered trademark of Saturn Fasteners, Inc.

W103152790

r

2. Move the door strike

/°

Using a Torx_t T25 screwdriver, remove the 2 screws securing

the door strike to the door frame of the dryer. Remove the 4
screws above and below the door strike and set aside for later

use. Rotate the strike 180° and attach to the opposite side of
dryer door frame, as shown.

4. Remove outer door trim

Not used on all models

On some models, you will need to use a Phillips screwdriver
to remove 4 screws attaching the outer door trim to the outer
door liner/window assembly. Lift off trim.

3. Remove inner door from outer door

Release tab _

;

Release tab

Not used on all models

Position the door with the inside of the door facing up.

Using a Phillips screwdriver, remove the 13 screws (17 screws

on some models) securing the inner door to the outer door.

Lift off the inner door and set aside.

NOTE: There is a small release tab on each side of the door.

If the inner and outer door do not separate easily, slide a

credit card, putty knife, or similar flat object between the inner
and outer doors at the locations shown to release the tab.

Remove door handle screws

1}

Using a Phillips screwdriver, remove the 2 screws attaching
the outer window and door handle to the outer door liner and

remove.

1-® TORX is a registered trademark of Saturn Fasteners, Inc.

2

6, Remove cover strip

_, Rotate outer window and reattach

door handle

Using a Phillips screwdriver, remove the 2 screws attaching
the cover strip to the outer door liner and remove.

7, Install cover strip from kit

Using the 2 screws removed earlier, install the new cover strip
(included with kit) on the opposite side.

Rotate the outer window and door handle 180° and lower
outer door liner back onto the outer window, securing the

door handle with the 2 screws removed earlier.

9, Reattach outer door trim

Not used on all models

Place the outer door trim on the outer door assembly. If you
removed 4 screws earlier, use a Phillips screwdriver to secure
trim in place using those screws.