Maytag MVWB750WB Dimension Guide

Top-Loading Washer

PRODUCT MODEL NUMBERS

MVWB400V, MVWB700V,
MVWB750W, MVWB300W,
MVWB450W, MVWB750W,
MVWB850W, MVWB755Y

Electrical: A 120 volt, 60 Hz., AC only, 15- or 20-amp,
fused electrical supply is required. A time-delay fuse
or circuit breaker is recommended. It is recommended
that a separate circuit serving only this washer be
provided.

DRAIN SYSTEM

Drain system can be installed using a oor drain,
wall standpipe, oor standpipe, or laundry tub.
Select method you need.

39"

(990 mm)

Wall standpipe Floor standpipe

The standpipe drain requires a minimum diameter
standpipe of 2" (51 mm). The minimum carry­away capacity can be no less than 17 gal. (64 L)
per minute. A 2" (51 mm) diameter to 1" (25 mm)
diameter standpipe adapter kit is available. See
“Tools and Parts”.

The top of the standpipe must be at least 39" (990
mm) high and no higher than 96" (2.4 m) from the
bottom of the washer.

OVERALL DIMENSIONS

14"* max.
(356 mm)

48 in.2*

17"*

(432 mm)

27 1/2"

(699 mm)

Front view

1"

(25 mm)

1"

(25 mm)

Side view

27"

(686 mm)

Spacing for recessed area or closet installation

All dimensions show recommended spacing allowed, with tested spacing of
0" (0 mm) clearance on sides.

Additional spacing should be considered for ease of installation and ■
servicing.

Additional clearances might be required for wall, door, and oor ■
moldings.

Additional spacing should be considered on all sides of the washer to ■
reduce noise transfer.

For closet installation, with a door, minimum ventilation openings in the ■
top and bottom of the door are required. Louvered doors with equivalent
ventilitation openings are acceptable.

Companion appliance spacing should also be considered. ■

(310 cm2)

(155 cm2)

5"*

(127 mm)

24 in.2*

* Required spacing

The laundry tub drain system needs a minimum 20 gal. (76 L)
capacity laundry tub. The top of the laundry tub must be at least
39" (990 mm) above the oor and no higher than 96" (2.4 m) from
the bottom of the washer.

The oor drain system requires a siphon break that may

39"

(990 mm)

28"

(710 mm)

be purchased separately. See “Tools and Parts”. The siphon
break must be a minimum of 28" (710 mm) from the bottom
of the washer. Additional hoses might be needed.

Laundry Tub Floor

Because Whirlpool Corporation policy includes a continuous commitment to improve Dimensions are for planning purposes only. For complete details, see Installation
our products, we reserve the right to change materials and specications without notice. Instructions packed with product. Specications subject to change without notice.

Ref. W10240438B

01/2011