Makita UMLOOODW, UM1000D, UM1000DW Instruction Manual
m
Effective cutting
width
100
mm
14")
100
mm
(4")
MODEL UMlOOOD
100
mm
(4")
MODEL UMlOOODW
With Fast Charger
Net
weight
1
kg
12
2
lbsl
Strokes
per
min
1,000
Dimensions
IL
x W x
HI
320
mm
x
100
mm
x
108
mm
112-5/8" x 4" x 4 114")
INSTRUCTION MANUAL
Battery
Cartridge
7000
Voltage
Charging
time
72v
1
Hr
SPEC
IF
I
CAT
IONS
Model
UMlOOOD
*
Model
DC7100
Fast
Charger
input
output
A.C
only
50
Hr
~ 60
Hr
DC
72V
x
Manufacturer reserves the right to change specifications without notice
*
Note: Specifications may differ from country to country.
IMPORTANT
SAFETY INSTRUCTIONS
(For
All
Tools)
WARNING:
WHEN USING ELECTRIC TOOLS, BASIC SAFE-
TY PRECAUTIONS SHOULD ALWAYS
BE
FOLLOWED TO
SONAL INJURY, INCLUDING THE FOLLOWING:
REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, AND PER-
READ ALL INSTRUCTIONS.
1.
Be aware that this appliance is always in an operating condition, because
2.
Avoid Dangerous Environment
-
Don't use appliances in damp or wet
lo-
3.
Don't Use In Rain.
4.
Keep Children Away
-
All visitors should be kept at a distance from work
area.
5.
Dress Properly
-
Do not wear loose clothing or jewelry. They can be caught
in moving parts. Use of rubber gloves and substantial footwear is recommended when working outdoors.
6.
Use Right Appliance
-
Do
not use appliance for any job except that for
which
it
is intended.
7.
Avoid Unintentional Starting
-
Don't carry appliance with finger on switch.
8.
Don't grasp the exposed cutting blades or cutting edges when picking up
or holding the appliance.
9.
Don't Force Appliance
-
It
will do the job better and with less likelihood
of a risk of injury at the rate for which
it
was designed.
it
does not have to be plugged into an electrical outlet.
cations.
IO.
Don't Overreach
-
Keep proper footing and balance at all times.
11.
Store Idle Appliances Indoors
-
When not in use, appliances should be
stored indoors in dry, high or locked-up place
-
out of reach of children.
12.
Maintain Appliance With Care
-
Keep cutting edge sharp and clean for
best performance and to reduce the risk of injury. Follow instructions for
lubricating and changing accessories.
2
IMPORTANT SAFETY INSTRUCTIONS
Length of Cord (Feet)
AWG Size of Cord
1.
SAVE THESE INSTRUCTIONS
-
This manual
25 50
100 150
18 18
18 16
contains important safety and operating instructions for battery charger.
2.
Before using battery charger, read all instructions and cautionary markings
on
(1)
battery charger,
(2)
battery, and
(3)
product using battery.
3.
CAUTION
-
To reduce risk of injury, charge only MAKITA Battery
7000.
Other types of batteries may burst causing personal injury and damage.
4.
Do
not expose charger to rain or snow.
5.
Use of an attachment not recommended or sold by the battery charger
manufacturer may result
in
a risk of fire, electric shock, or injury to persons.
6.
To reduce risk of damage to electric plug and cord,
pull
by plug rather than
cord when disconnecting charger.
7.
Make sure cord is located
so
that
it
will
not be stepped on, tripped over, or
otherwise subjected to damage or stress.
8.
An extension cord should not be used unless absolutely necessary. Use of
improper extension cord could result
in
a risk of fire and electric shock. If
extension cord must be used, make sure:
a.
That pins on plug of extension cord are the same number, size, and shape
b. That extension cord is properly wired and
in
good electrical condition; and
c. That wire size is at least as large as the one specified in the table below.
TABLE
1
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS
FOR
BATTERY CHARGERS
as those of plug on charger;
9.
Do
not operate charger
with
damaged cord or plug
-
replace them im-
mediately.
IO.
Do
not operate charger if
it
has received a sharp blow, been dropped, or other-
wise damaged
in
any way; take
it
to a qualified serviceman.
11.
Do not disassemble charger or battery cartridge; take
it
to a qualified
serviceman when service or repair is required. Incorrect reassembly may
result in a risk of electric shock or fire.
12.
To
reduce risk of electric shock, unplug charger from outlet before attempt-
ing
any maintenance or cleaning. Turning off controls
will
not reduce this risk.
3
ADDITIONAL SAFETY RULES
FOR CHARGER
&
BATTERY CARTRIDGE
1.
Do
not charge Battery Cartridge when temperature is BELOW 10°C (5OOF)
2.
Do not attempt to use a step-up transformer, an engine generator or DC power
3.
Do
not allow anything to cover
or
clog the charger vents.
4.
Do not short the battery cartridge:
or ABOVE
4OoC
(104OF).
receptacle.
(1)
Do not touch the terminals
with
any conductive material.
(2)
Avoid storing battery cartridge
in
a container
with
other metal objects such
(3)
Do not expose battery cartridge to water or rain.
as nails, coins, etc.
A battery short can cause a large current
flow,
overheating, possible burns
and even a breakdown.
5.
Do
not store the tool and Battery Cartridge in locations where the tempera-
6.
Do
not incinerate the Battery Cartridge even if
it
is severely damaged or is
ture may reach or exceed 5OoC (122OF).
completely worn out. The battery cartridge can explode
in
a fire.
SAVE THESE INSTRUCTIONS.
4
Loading...