Makeblock NU001BT User Manual

User Guide

The Neuron Bluetooth Module is a hardware module designed specifically

for STEM education. It comes with built-in bluetooth.

The Bluetooth block has two functions:
Establish a wireless connection between the blocks and tablet computer
within 10 meters, then you can program the blocks via Neuron APP.
Contain a micro USB interface. You can connect the block to power bank,
computer or power adapter via USB cable to power the other blocks.

You can power the Bluetooth block by Micro USB interface by connecting to
power bank, computer or power adapter via USB cable, or connect to Neuron
Power block. The led will be light up and blink. When you open Makeblock
Neuron App, and put your phone or pad close to the Bluetooth block, the
block will link with the APP automatically. Then you can start your
graphical programming trip.

FCC STATEMENT:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may

cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.

RF warning statement:

The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.