Macrom M-DVD5560 User Manual
USER MANUAL
M-DVD5560
- 1 -
Safety Precautions
Never expose this unit, amplifier, and
speakers to moisture or water to prevent
electric sparks or fire.
Please don't change the fuse on the power
cord without professional guidance, using
improper fuse may cause damage to this unit
or even cause fire.
Please contact your nearest dealer if one of
the following symptoms is experienced:
(a). Water or other objects enters the unit.
(b). There is smoke.
(c). Peculiar smell.
Only connect the unit to a 12-volt power
supply with negative grounding.
Never install this unit where the operation &
condition for safe driving is impaired.
Never use the video display function in the
front when driving to prevent the violation of
laws & regulations and also to reduce the
risk of traffic accident except for using rear
view video camera.
MUTE
OK
Thank you for purchasing this product. Please
read through these operating instructions
so you will know how to operate your model
properly. After you’ve finished reading the
instructions, keep this manual in a safe place
for future reference.
To ensure safe driving, please adjust the
volume to a safe and comfortable level in
case of emergency situations.
- 2 -
1. Never disassemble or adjust the unit without any professional guidance.
For details, please consult any professional car shop / dealer for inquiry.
2. If the front panel or TFT monitor is dirty, please use a clean silicone cloth and neutral detergent
to wipe off the spot. Using a rough cloth and non-neutral detergent such as alcohol for cleaning
may result in scratching or decoloration to the monitor.
3. If any abnormal behavior of the unit is found, please refer to trouble shooting guide of this
manual. If no relevant information is found, please press the [RESET] key on the front panel to
resume factory default.
4. If you have parked the car in hot or cold weather for a long time, please wait until the
temperature in the car becomes normal before operating the unit.
5. Using the car heater in low temperature environment may result in moisture inside the unit, DO
NOT use the unit in this situation. Eject the disc and wipe off the moisture on the disc. If the unit
still doesn't work after a few hours, please contact the service center.
6. Do not impact the LCD monitor which could cause damage.
7. To prevent damage to the screen, avoid touching it with sharp objects.
8. To provide a clear demonstration and an alternative for easy understanding to the operation of
this unit, graphic illustrations are used.
However, some illustrations are different from the actual images displayed on the screen.
9. Operate the unit correctly according to this manual to prevent unnecessary problem. The
guarantee won't be valid if the problem is caused by inappropriate operation.
Safety Precautions
Note:
The items listed outside of the frame are the commercial products generally sold.
VOL
SD Card
Power Amplifier
Rear
Monitor
Rear vision
Monitor
Portable player
(connected via AV Input)
USB
memory
Bluetooth
cellular phone
Expanding audio feautres
Expanding visual feautres
Expanding System
- 3 -
Contents
Safety Precautions ....................................1-2
Contents ........................................................ 3
Produc overview ........................................... 4
Front Panel ............................................... 4
Basic Operations .......................................... 5
Detect parking brake................................ 5
Mute .......................................................... 5
Power On / Off .......................................... 5
Audible Beep Confirmation ...................... 5
Playing Source Selection ......................... 5
EQ Menu.................................................... 6
Select Preset Equalizer ............................ 6
Adjust EQ Parameters .............................. 6
Adjust FAD BAL ....................................... 6
Set Date .................................................... 7
Set Clock Mode ......................................... 7
Set Time .................................................... 7
Radio Mode ................................................... 8
Tuner TFT Display .................................... 8
Select Radio as Playing Source ............... 8
Select One Radio Band ............................. 8
Tune the radio........................................... 8
Preset Station ........................................... 9
local Seeking ............................................ 9
RDS Basics ............................................... 9
Adjust RDS Settings ................................. 9
RDS ( Radio Data System ) ..................... 10
AF Function ............................................. 10
EON ( Enhanced Other Networks ) ........ 10
TA Function ............................................. 10
CT (Clock Time) ...................................... 10
PTY Function ........................................... 10
Playback Mode ........................................... 11
Load a Disc ............................................. 11
Eject a Disc ............................................. 11
Touch Screen Controls .......................... 11
Controlling Playback .............................. 11
Connect a USB Device ............................ 11
Remove a USB Device ............................ 11
Insert a SD/MMC Card ........................... 11
Remove a SD/MMC Card........................ 11
Play/Pause .............................................. 11
Previous/Next ......................................... 11
Search for a Folder ................................ 12
Repeat ..................................................... 12
Repeat A-B ............................................. 13
Shuffle (Random) Play ............................ 13
Select Audio Mode .................................. 13
Select Subtitle Language ....................... 13
Playback Information ............................. 14
Direct Track Entry .................................. 14
Rotate Pictures ....................................... 14
Zoom ....................................................... 14
Video Setup ............................................. 14
Bluetooth Mode .......................................... 15
Pair the Bluetooth-enabled Devices...... 15
Disconnect Bluetooth Device ................. 15
Make a Call ............................................. 15
Receive a Call ......................................... 16
Adjust Bluetooth Settings ...................... 16
Bluetooth Musci Mode ........................... 16
Settings ....................................................... 17
General settings ..................................... 17
Calibration .............................................. 17
Video settings ......................................... 17
Sound settings ........................................ 18
Time settings .......................................... 18
Language settings .................................. 18
Bluetooth settings .................................. 18
DVD settings ........................................... 19
Volume settings ...................................... 19
Other Modes ............................................... 20
ther Devices ............................................ 20
Reset ....................................................... 20
Replace a Fuse ....................................... 20
Navigation (GPS) ..................................... 20
SWC Programming ................................ 20
Specifications ............................................. 21
Region Code ........................................... 22
Cautions when using Discs .................... 22
Troubleshooting ......................................... 23
Wire Connections ....................................... 24
- 4 -
Front Panel
1. [ ] Button
Press to eject a disc.
2. [MENU] Button
Press to switch between the available audio/video sources applied to the unit.
3. [VOL/
/ ] Knob
Rotate to adjust the volume.
Press momentarily to activate the MUTE function. Press again to resume normal
listening.
Press to turn the unit ON. Press and hold to turn the unit OFF.
4. Reset Button
Press to reset system settings to factory default (except password and parental lock
settings).
5. SD Interface Connector
Insert an SD card for playback of music/video files.
6. Map Slot
The Mini SD card is used for the Navigation Map only, not for music or other files.
This may be used for firmware updates if required.
7. A/V Input
Accepts a 3.5mm jack through which signals from various audio/video devices can be
applied to the unit.
8. USB Connector
Connect a USB device for playback of music/video files.
9. Remote Sensor (optional)
10. Disc slot
11. Internal Microphone
Internal microphone for Bluetooth calls.
Product overview
Notice:
The graphic in this manual is for reference only, and may be different from the actual unit.
VOL
1
11 10 9
2
3
4
5
6
7
8
- 5 -
Detect parking brake
• Connect the cable "BRAKE" to the parking brake switch to view video files on the TFT monitor.
Engage the parking brake for viewing videos.
• Whenthe parkingbrakeisnotengaged, themonitor displays"Warning!!!,Videoplayback is
disabled for your safety. Engage parking brake to watch video.", preventing the driver to watch
content while driving. The rear screens are not interested in this inhibition.
Mute
Press [
VOL/ /
] knob to mute the volume from the unit. Press again to restore the volume. [
] is displayed on the LCD. Adjusting the volume or using any of the audio setup features cancels
the mute function.
Power On / Off
Press the [
VOL/ /
] knob on the unit to turn the unit on. The buttons on the front of the unit
light up for a moment and the current mode status appears in the LCD.
Press and hold the [
VOL/ /
] knob to power off the unit.
Audible Beep Confirmation
An audible beep tone confirms each function selection. The Beep tone can be disabled through the
Setup menu.
Playing Source Selection
Press the [ MENU ] button on the front panel to change between available playing sources. The
playing mode is displayed on the screen.
1. 1/2 or 2/2: Touch this page button to view the first or second page of on-screen buttons
2. Function icons
3. Clock
4. Touch for quick access to Equalizer level settings
Basic Operations
1
2
3 4
1
- 6 -
Select Preset Equalizer
1. Enter the EQ setup mode
Touch the [
] icon in the user interface and the
EQ setup interface will display on the screen.
2. Select EQ mode
Touch the desired EQ selection: [ Optional ] /
[ Classic ] / [ Rock ] / [ Jazz ] / [ Techno ] / [ Pop ],
and the EQ mode will change.
Adjust EQ Parameters
To adjust EQ parameters, touch and drag the parameters adjustment bar.
[ User ]: Set the desired audio effect.
[ Flat ]: Select the original audio effect.
[ Reset ]: Cancel the equalizer function settings.
[ Loud: On/Off ]: When listening to music at low volumes, this featurewill selectively boost certain
bass and treble frequencies.
Adjust FAD BAL
You can adjust front/back/left/right balance of the speaker and the subwoofer volume to get
balanced listening effect according to the surroundings and your interest.
1. Enter the EQ setup mode
Touch the [
] icon in the user interface and the EQ
setup interface will display on the screen.
2. Adjust subwoofer volume
Touch [
] / [ ] or drag [ ] to adjust subwoofer
volume from -12 to +12.
3. Adjust fader / balance value
Touch [ ] / [ ] / [ ] / [ ] to adjust fader /
balance value from -20 to +20.
[ ]: Front speaker
[ ]: Rear speaker
[ ]: Left speaker
[ ]: Right speaker
Basic Operations
EQ Menu
The Audio Control feature allows you to easily adjust your audio system to meet the acoustical
characteristics of your vehicle, which vary depending on the type of vehicle and its measurements.
Proper setting of the Fader and Balance boosts the effects of the cabin equalizer.
Notes:
1. The parameters of the EQ modes has been preset and you can not change them besides ‘User’.
2. The EQ mode will change to ‘User’ automatically when you adjust the frequency value under the
modes besides ‘User’.
3. The value of Sub is independent of EQ mode and can be adjusted separately.
- 7 -
Setting Date /Time
1. Touch [ Settings].
2. Touch [ Time ].
The date/time setup menu is displayed.
Set Date
1. Touch [ Date ].
2. Touch the date information on the screen .
A submenu is displayed.
3. Touch [ ] or [ ] to set year, month and day.
Set Clock Mode
1. Touch [Clock mode].
2. Touch [12Hr] or [24Hr] to switch clock mode.
Set Time
1. Touch [ Time ].
2. Touch the time on the screen, a submenu is displayed.
3. Touch [
] or [ ] to set hour and minute.
4. When date/time is set, touch [ Save ] to confirm or [ Cancel ] to exit.
Loading...