Mackie 2043589 Installation Guide
iPad Air Tray Kit Installation Instructions
IMPORTANT!
The contents of this kit allow you to replace the iPad tray insert currently installed on the DL806 or DL1608 mixer
with an iPad Air tray insert. Before installing, ensure that you have the right iPad, docking connector and tray insert
for your combination. See the iPad to DL Compatibility Matrix for the latest information:
http://www.mackie.com/products/dlseries/specs
Please first read these instructions carefully to ensure you feel capable of completing the described tasks. Failure
to follow the exact instructions in this document may result in personal injury or damage to the DL806, DL1608, iPad,
or contents of the kit and may void the warranty, as well.
Web: http://www.mackie.com/support
Email: techmail@loudtechinc.com
Phone: 425-487-4333
Toll-free: 800-898-3211
Parts
iPad Air Tray Kit Contents – Part No. 2043589:
iPad Air Tray Insert – Part No. 2042082
Four (4) Black Nylon Washers – Part No. 2037889
This instruction sheet – Part No. 2043591
Tools
Required Tools (not included):
#1 Phillips screwdriver
iPad Tray Insert Removal
1. Remove the four screws holding the tray insert
to the mixer, numbered 1 to 4 in the illustration below.
Keep the screws in a safe place, as you will use them
again.
2
1
4
3
2. Remove the tray insert from the mixer and save it
somewhere safe! You might need to use it again.
Tray
Tray Insert
iPad Air Tray Insert Install
1. Slide the iPad Air tray insert on top of the mixer tray,
making sure to line up the sides and the screw holes.
Tray Insert
Tray
2. Place the screws back into the DL mixer from where
you just removed them. Screw them into place, but do not
overtighten. If the iPad fit is too tight, loosen all four screws,
then tighten the ones closest to the connector first.
3. To use the PadLock
™
, you will need to install the two
nylon washers (included in this kit). Align them flat against
™
the threads of each PadLock screw
, put the driver into the
screw head and slowly turn the screw to thread the washer
over the screw threads. Apply moderate pressure against the
washer while turning the screw so the washer threads. Stop
when the washers clear the screw threads.
LOUD Technologies Inc. • 16220 Wood-Red Road NE
Woodinville • WA • 98072 • 800/258-6883
Outside the U.S. call 425/487-4333 • FAX 425/487-4337
Part No. SW1059 Rev A 02/14
© 2014 LOUD Technologies Inc. All Rights Reserved.
Disclaimer: LOUD Technologies Inc. continually engages in research related to product improvement.
New material, production methods, and design renements are introduced into existing products without
notice as a routine expression of that philosophy. For this reason, any current LOUD Technologies Inc.
product may differ in some respect from its published description, but will always equal or exceed the
original design specications unless otherwise stated.
Loading...