Louroe Electronics VERIFACT L-DT Installation And Operating Instructions Manual

®

6955 VALJEAN AVE, VAN NUYS, CA 91406

PH: [phone] / FAX: [phone]

/ [e-mail]

INSTALLATION AND OPERATING INSTRUCTIONS

VERIFACT™ L-DT

MICROPHONE

VERIFACT™ L-DT

The LOUROE Model L-DT Microphone is designed for desktop applications in
interview rooms, speech therapy labs, cashier booths, etc. It contains 2
microphones facing opposite directions. Model L-DT is a low impedance, electret
condenser microphone and produces line level output.

Wire color code: Red 12Vdc

Black Audio output
Bare Ground

If using wiring from other manufacturers color code may vary.

SPECIFICATIONS

Output
Sensitivity

(microphone & preamp)

Frequency response
Current drain
Supply voltage 12 Vdc
Output impedance
Microphone housing High impact ABS
Dimensions - US

- Metric 12 cm L x 7.6 cm W x 4.4 cm H

Weight (net) 0.5 Lbs (0.2 kg)

Line Level (0 dB @ 1000Ω)
80 dB SPL input

provides 0.254V RMS

40 Hz to 15 kHz ± 1 dB
4 mA

600Ω unbalanced

4 ¾”L x 3”W x 1 ¾”H

L-DT_mic_inst_4/11

INSTALLATION AND OPERATING INSTRUCTIONS

CONNECTION TO LOUROE RECEIVING DEVICE
(Audio Base Station or Audio Interface Adapter)

All Louroe receiving devices (base stations, interface adapters) have a corresponding terminal block marked A, B, C.
Observing wire color code, connect other end of cable matching:

A to A
B to B

C to C
Also refer to installation instructions for the specific model base station or interface adapter. Maximum cable run between
microphone and receiving device is 1,000 ft. (305 m).

MICROPHONE POSITIONING

The L-DT can be placed directly on a desktop or any flat surface. It has a weighted bottom with rubber padding for
positive grip. For best results, persons should be 2 - 4 ft. (0.6 m - 1.2 m) from the microphone.

ELECTRICAL CONNECTION

Model L-DT connects directly to any Louroe base station or audio interface adapter. A terminal block is located on the
back of Model L-DT Microphone housing, marked A, B, C.

A is 12 Vdc (power)
B is Audio Output
C is Ground

All Louroe base stations and audio interface adapters have a corresponding terminal block (A, B, C) for each zone. Using
recommended wiring, connect microphone to the receiving device as follows:

MICROPHONE CONNECTION

RED wire (12 Vdc) goes to terminal A
BLACK wire (Audio Out) goes to terminal B
BARE wire (ground) goes to terminal C

LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL [phone] FAX [phone]

®

website: www.louroe.com e-mail: [e-mail]

Page 2 of 4

(818)

LD-T_mic-inst_4/11

INSTALLATION AND OPERATING INSTRUCTIONS

MICROPHONE SENSITIVITY SWITCH

For special installations that require less microphone sensitivity, a sensitivity switch is located on
the back side of the Model L-DT near the terminal strip. An opening is marked N and L. N is
normal and L is low (-6 dB output into 1KΩ ). With a small screwdriver, move slide switch to L

position. Model L-DT is always shipped with sensitivity switch in the N position. Do not change
unless necessary.

Bottom View of L-DT

LOUROE

MODEL L-DT MICROPHONE

RED

BARE (C)

L

N

A B C

RED (A)

BLACK (B)

BLACK

BARE

A

C

To Louroe

B

Audio Base

Station or Audio

Interface Adapter

Microphone Terminal

Block Identitier

A = +12Vdc
B = Audioput
C = Ground

WIRING REQUIREMENTS

2 Conductor shielded cable, 22
gauge with a 24 gauge drain wire

NOTE: Unshielded cable is not

satisfactory for audio systems

West Penn 452 or equivalent

All Louroe Microphones, Audio
Base Stations and Audio
Interface Adapters contain 3-pin
terminal blocks marked A, B, C.

LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL [phone] FAX [phone]

®

website: www.louroe.com e-mail: [e-mail]

Page 3 of 4

(818)

LD-T_mic-inst_4/11

MANUFACTURED

IN THE

IMPORTANT NOTICE

When this equipment is used as part of an
audio monitoring system, the law requires
that the public be given notice of AUDIO
MONITORING ON THE PREMISES. A
deca l noti ce is included with each
microphone shipped.

Federal Law References:
Federal Regulations, US Code, Title 18.
Crime and Criminal Procedure, Sec 2510.

AUDIO

MONITORING

On

These Premises

®

LOUROE ELECTRONICS warrants that at the time of shipment products manufactured by LOUROE ELECTRONICS to be free of defects in material and workmanship.
Should a defect appear within one year (12 months) from date of shipment, LOUROE ELECTRONICS will, at its sole discretion, repair or replace the defective equipment.
This equipment shall not be accepted for repair or return without prior notification by LOUROE ELECTRONICS .

This warranty does not extend to any Louroe product that has been subjected to improper or incorrect installation, misuse, accident, or in violation of installation
instructions provided by LOUROE ELECTRONICS.

Returned shipments to LOUROE ELECTRONICS shall be at customer’s expense. LOUROE ELECTRONICS will return the equipment prepaid via best way.

LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL [phone] FAX [phone]

®

®

®

®

website: www.louroe.com e-mail: [e-mail]

WARRANTY

Page 4 of 4

®

®

®

(818)

LD-T_mic-inst_4/11