Louroe Electronics TLSP-PB-WF User Manual

®

6955 VALJEAN AVE, VAN NUYS, CA 91406

PH: [phone] / FAX: [phone]

/ [e-mail]

MODEL TLSP-PB-WF/TLSP-PB-WS

REMOTE CALL STATION

INSTALLATION AND OPERATING INSTRUCTIONS

MODEL TLSP-PB-WF

(FOR FLUSH MOUNTING)

MODEL TLSP-PB-WF

(FOR SURFACE MOUNTING)

INTRODUCTION (Refers to both TLSP-PB-WS and TLSP-PB-WF)

Model TLSP-PB is a vandal resistant call station designed to provide 2-way communication with a Louroe sound
activated alarming base station (Models DG-12II/DG-25III). It is designed for correctional facilities or areas of high
vandalism.

The unit consists of an electret condenser microphone, 3” (7.6cm) speaker and a vandal resistant callbutton, all mounted
to an 11 gauge stainless steel faceplate. When the TLSP-PB is interfaced with a Louroe sound activated base station,
the system can be activated either by a noise (scream, yell, etc.) that exceeds the threshold level, set at the base station
or by pressing the built-in call button. The call button sends a 3kHz tone that activates the base station, opening up a
two-way communication path. Included is a 6” x 6” x 4” (15cm x 15cm x 10cm) back box with tamper proof hardware.

Model TLSP-PB-WF is for flush mounting to a wall. Face plate dimensions are 7” x 7” (18cm x 18cm)
Model TLSP-PB-WS is the surface mounting to a wall. Face plate dimensions are 6” x 6” (15cm x 15cm)

LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL [phone] FAX [phone]

®

website: www.louroe.com e-mail: [e-mail]

Page 1 of 4

(818)

tlsp_pb_inst_3/15

INSTALLATION AND OPERATING INSTRUCTIONS

MICROPHONE AND SPEAKER

Located to the left of the PC Board and vertically positioned is a small terminal block
marked C, B, A. See drawing on Page 3.

Microphone

Using shielded portion of recommended wiring:

1) RED wire goes to terminal A (12 Vdc supply)

2) BLACK wire goes to terminal B (audio output)

3) BARE wire (drain) goes to terminal C (ground)
The blank pin between terminal C and B is not used.

Speaker:
Mounted next to speaker is a 70V transformer with two lead wires WHITE and GREEN. Using wire nuts,
connect these two wires to the unshielded WHITE and GREEN cables of recommended wiring (West
Penn 356 or equivalent)

CONNECTING MODEL TLSP-PB TO A LOUROE BASE STATION

If TLSP-PB is to be connected to a Louroe Model DG-12II or DG-25III Alarming Base Station, please
refer to the installation instructions that accompany the DG12II or DG25III.

SPECIFICATIONS (Model TLSP-PB-WF and TLSP-PB-WS)

Output of microphone (Mic)

Frequency Response (Mic)
Current Drain (mic)

Speaker

Faceplate (TLSP-PB-WS)

Faceplate (TLSP-PB-WF)

Backbox

Weight

Shipping Weight

LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL [phone] FAX [phone]

®

website: www.louroe.com e-mail: [e-mail]

Line Level (0 dB, 600W @ 1KW)
40 Hz to 15 kHz
10 mA
3”, 2W w/ 70V transformer

6”L x 6”W

7”L x 7”W

6”H x 6”W x 4”D

4 lbs

7 lbs

Page 2 of 4

Vandal Resistant
Stainless Steel

(818)

tlsp_pb_inst_3/15

INSTALLATION AND OPERATING INSTRUCTIONS

WIRING DIAGRAM FOR MODEL TLSP-PB-WF/TLSP-PB-WS

SPEAKER/MICROPHONE

TLSP-PB REAR

CALL BUTTON SWITCH

Terminal Block Identification
Microphone
C - Ground
B - Audio Output
A - 12Vdc Power

Green wire (positive)
White wire (negative)
are speaker connections

MICROPHONE
CONNECTION

WHITE

SPKR (-)

GREEN

SPKR (+)

WIRE NUT

A
B

C

GREEN (+)

WHITE (-)

POSITIVE

}

NEGATIVE

ABC

}

WHITE

RED

BLACK

BARE

RED (A)

BARE (C)

BLACK (B)

MICROPHONE

11 GAUGE STAINLESS
STEEL FACE PLATE

WIRING REQUIREMENTS

4 Conductor consisting of:

+

2 Conductor shielded, 20 gauge
with 22 gauge drain (microphone
connection)

+

2 Conductor unshielded, 18 gauge

(speaker connection)

UNSHIELDED

SPEAKER

AND ALARM

CONNECTION

NOTE: WHEN USING CABLE FROM OTHER

MANUFACTURERS, COLOR CODE
MAY VARY

TO DG12II / DG25III

LOUROE BASE STATION

LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL [phone] FAX [phone]

®

SHIELDED
MICROPHONE
CONNECTION

(818)

website: www.louroe.com e-mail: [e-mail]

Page 3 of 4

tlsp_pb_inst_3/15

INSTALLATION AND OPERATING INSTRUCTIONS

MANUFACTURED

IN THE

When this equipment is used as part of an
audio monitoring system, the law requires
that the public be given notice of AUDIO
MONITORING ON THE PREMISES. A
deca l noti ce is includ ed with each
microphone shipped.

Federal Law References:
Federal Regulations, US Code, Title 18.
Crime and Criminal Procedure, Sec 2510.

LOUROE ELECTRONICS warrants that at the time of shipment products manufactured by LOUROE ELECTRONICS to be free of defects in material and workmanship.
Should a defect appear within one year (12 months) from date of shipment, LOUROE ELECTRONICS will, at its sole discretion, repair or replace the defective equipment.
This equipment shall not be accepted for repair or return without prior notification by LOUROE ELECTRONICS .

This warranty does not extend to any Louroe product that has been subjected to improper or incorrect installation, misuse, accident, or in violation of installation
instructions provided by LOUROE ELECTRONICS.

Returned shipments to LOUROE ELECTRONICS shall be at customer’s expense. LOUROE ELECTRONICS will return the equipment prepaid via best way.

®

®

®

IMPORTANT NOTICE

MONITORING

These Premises

WARRANTY

AUDIO

On

®

®

®

®

LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL [phone] FAX [phone]

®

(818)

website: www.louroe.com e-mail: [e-mail]

Page 4 of 4

tlsp_pb_inst_3/15