Longshine LCS-GSP8108 User Manual

LCS-GSP8108

8-Port Gigabit Ethernet

PoE+ Desktop Switch

User’s Manual

English

FCC Certifications

This Equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful

interference when the equipment is operated in a

commercial environment. This equipment generates,

uses, and can radiate radio frequency energy and, if

not installed and used in accordance with the

instruction manual, may cause harmful interference to

radio communications.Operation of this equipment in

a residential area is likely to cause harmful

interference in which case the user will be required to

correct the interference at his own expense.

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1)

this device may not cause harmful interference, and (2)

this device must accept any interference received;

including interference that may cause undesired

operation.

CE Mark Warning

This equipment complies with the requirements

relating to electromagnetic compatibility, EN 55022

class B for ITE, the essential protection requirement of

Council Directive

2004/108/EC on the approximation

of the laws of the Member States relating to

electromagnetic compatibility.

Company has an on-going policy of upgrading its

products and it may be possible that information in this

document is not up-to-date. Please check with your

local distributors for the latest information. No part of

this document can be copied or reproduced in any

form without written consent from the company.

Trademarks:

All trade names and trademarks are the properties of

their respective companies.

Copyright © 2012, All Rights Reserved.

Unpacking Information

Thank you for purchasing this product. Before

installation, please verify that your package contains

the following items.

1. One 8-port Gigabit Ethernet with 8-port

PoE+ Desktop Unmanaged Switch

2. 1* AC power cord

3. Rubber feet and screws

4. User’s Manual

5. 2* Brackets

6. 1*Wall mount accessory

Introduction

General Description

The device is a powerful, high-performance Gigabit

Ethernet Switch, with all 8 ports capable of

10/100/1000Mbps auto-negotiation operation (NWay),

which means the switch could automatically negotiate

with the connected partners on the network speed and

duplex mode. It is ideal for micro-segmenting large

networks into smaller, connected subn et s for improv ed

performance, enabling the bandwidth demanding

multimedia and imaging applications. Moreover, the

10/100/1000Mbps auto-sensing ability provides an

easy way to migrate 10/100Mbps to 1000Mbps

network with no pain.

This switch supports PoE, which supplies power for

connected devices via CAT 5 and above twisted

cables. By integrating the data transmitting cable and

power cord, it eliminates the effort constructing your

network. You could easily connect a Wireless AP or a

VoIP phone to this switch without looking outlets for

them. Over current protection and circuit shorting

protection are also supported to ensure the safety.

The switch is plug-n-play without any software to

configure and also fully compliant with all kinds of

network protocols. Moreover, the rich diagnostic LED

indicators on the front-panel provide the operating

status of individual port and whole system.