Page 1
Monroe, Wa. 360 453 2030 www.longacreracing.com
AccuLevel
8/06
™
(Ver. 1.2)
Digital Level Measurment from 0.0O to 90.0
Pointers on display - show direction of tilt.
(If
AccuLevel™
front end camber this will tell whether
camber is posative or negative.)
is used for measuring
1.2
SWITCH
SOUND
Turn on: Push “SWITCH” (hold 1 sec.)
extend battery life.
TEST MODE
Note direction of pointers
0.3
KEEP
AccuLevel™
O
0.3
LEVEL
Battery:
Remove black end cap
to access. Replace when
needed with a good
quality alkaline 9 volt.
shuts off after 5 minutes to
To hold reading: Push “KEEP” (hold 1 sec.) The reading will be held on the display,
indicated by H. Push “KEEP” again (hold 1 sec.) to go back to active reading.
To calibrate: Place
10 seconds. Push “TEST”. CAL1 will appear on the display.
same spot, let it stabilize again for 10 seconds, and push “TEST” again. Display will
show CAL2, then go back to normal degree display. You are done.
MODE:
absolute degrees to .1 (1/10) degree Modes 2 & 3 are used in construction trades.
Mode 2 is the % of 45
SOUND: Push this button and
AccuLevel™
AccuLevel™
has 3 different modes. 1) is the primary mode and shows
O
and Mode 3 is inches per foot of slope.
on a reasonably level table top. Let it stabilize for
Turn around 180O in the
AccuLevel™
will beep when it gets to 0O or 90O.
Shut the unit off when done to save battery life.
This version does not have an automatic shutoff.
Do not drop the unit. Keep it clean and dry and avoid strong
electrical or magnetic fields. Do not push 2 buttons at once.
Loading...