Linksys WRT300N, WRT350N Quick Start Manual
2
Model No.
Model No.
4
,
Package Contents
• Wireless-N Broadband Router
• Setup CD-ROM with Norton Internet Security
•User Guide on CD-ROM
• Ethernet Network Cable
• Power Adapter
• Quick Installation
GHz
Wireless-N
Broadband Router
Wireless
Wireless
Quick Installation Guide
WRT300N (EU/LA/UK)
1
There are two ways to configure the Router. Choose one of the following:
• Run the Setup CD-ROM - Insert the Setup CD-ROM into the CD-ROM
drive, and follow the on-screen instructions.
•Use this Quick Installation Guide - If you wish, you can use the Router’s
Web-based Utility. Proceed to Step 1 of this Quick Installation.
1
Connect the Router
A Make sure that all of your
hardware is powered off,
including the broadband
modem and PCs.
B Connect your broadband
modem’s Ethernet cable to
the Router’s Internet port.
C Connect one end of an
Ethernet network cable to one
of the numbered ports on the
back of the Router. Connect
the other end to an Ethernet
port on a network device, e.g.,
a PC, print server, or switch.
Repeat this step to connect
more PCs or other network
devices to the Router.
B
C
D Power on the broadband
modem.
2
E Connect the included power
adapter to the Router’s Power
port, and then plug the power
adapter into an electrical
outlet. The Power LED on the
front panel will light up when
the adapter is connected
properly.
F Power on your PC(s).
G Locate an optimum location
for the Router. The best place
for the Router is usually at the
center of your wireless network,
with line of sight to all of your
wireless devices.
Proceed to Step 2.
E
IMPORTANT: Make sure you
use the power adapter that is
supplied with the Router. Use of
a different power adapter could
damage the Router.
3
2
NOTE: Make sure your PC’s Ethernet
adapter is set to obtain an IP address
automatically. For more information,
refer to Windows Help.
Configure the Router
A Open your web browser. Enter
http://192.168.1.1 in its
Address field. Press the Enter
key.
B A password request screen will
appear. Leave the User name
field blank, and enter the
default password, admin, in
the Password field. (For added
security, you should later set a
new password, using the
Administration tab’s
Management screen of the
Web-based Utility). Then click
the OK button.
B
C The Web-based Utility will
appear with the Setup tab
selected. If requested by your
Internet Service Provider (ISP),
complete the Host Name and
Domain Name fields. (These
are usually requested by cable
ISPs.) Otherwise, leave them
blank.
4
C
Loading...