Linear DXS-62-EC, DXS-63-EC User Manual

DXS-62/EC DXS-63/EC

SUPERVISED EMERGENCY TRANSMITTERS

Operation Instructions

(760) 438-7000 • FAX (760) 438-7043

www.linearcorp.com

WRISTBAND INSTALLATION PENDANT HOLDER INSTALLATION POCKET CLIP INSTALL ATION

PRODUCT DESCRIPTION

FEATURES

The Models DXS-62 and DXS-63 are battery powered, miniature, water-resistant*, supervised transmitters designed for use in emergency

applications with Linear’s DX and DXS Format receivers. Each is supplied with a wristband, a pocket clip, and a Nylon pendant necklace. Pressing buttons on either transmitter sends a digital coded wireless signal to its

ACTIVATION

BUTTON

SIGNAL

INDICATOR

companion receiver. To insure sending a complete signal, press the transmitter button(s) for a minimum of two seconds.

Each DXS transmitter is factory set to a unique code, so no ﬁ eld coding is required. The one-button DXS-62 sends a signal when its button is pressed. The two-button DXS-63 transmitter sends a signal when both buttons are pressed together. These transmitters can send a signal for up to 30seconds per activation. The red signal indicator on the transmitter lights and a built-in sounder beeps when the unit is activated. If status transmissions are enabled, they will be sent every two hours. Some receivers are able to use these signals, others are not.

DXS-62

NYLON

NECKLACE

DXS-63

ACTIVATION

BUTTONS

(PRESS BOTH)

Every two hours the transmitter tests for a low battery. This test takes place even if status transmissions have not been enabled. If the battery tests low, the transmitter sounder will beep and a low battery signal will be sent. Receivers must be programmed to the transmitter’s code before system testing and operation. Refer to the receiver’s instructions for details on operation and programming. Each transmitter is sealed to provide water-resistance. The unit’s battery is not replaceable. The transmitter should be discarded at the end of its battery life.

* NOTE: Water resistance not tested by UL

PENDANT HOLDER

POCKET

CLIP

WRIST STRAP

TO INSTALL WRISTBAND, SLIDE STRAPS INTO SLOTS ON ENDS OF TRANSMITTER

NOTE: THE END OF STRAP WITH VELCRO ATTACHES TO THE END CLOSEST TO THE SIGNAL INDICATOR

STATUS OPTION & PROGRAMMING SYSTEM TESTING INTERNATIONAL WARRANTY

IF THE FOUR HOUR STATUS TIMER IS REQUIRED FOR SUPERVISION, PERMANENTLY ENABLE THE TIMER BY PRESSING THE TRANSMITTER BUTTON FIVE TIMES IN SUCCESSION (USE THE LEFT BUTTON ON DXS-63). THE DXS-62 WILL BEEP AFTER EACH BUTTON PRESS, THE DXS-63 WILL NOT. FIVE BEEPS WILL SOUND WHEN THE TIMER IS ENABLED.

BEEP... BEEP...

BEEP

BEEP... BEEP...

PROGRAM THE TRANSMITTER INTO THE RECEIVER BY PLACING THE RECEIVER INTO PROGRAM MODE, THEN SEND A SIGNAL TO THE RECEIVER FROM THE TRANSMITTER. REFER TO THE RECEIVER'S PROGRAMMING INSTRUCTIONS FOR DETAILS.

TO INSTALL PENDANT HOLDER, SLIDE HOLDER INTO SLOTS ON ENDS OF TRANSMITTER

NOTE: NECKLACE SIDE OF PENDANT HOLDER FITS CLOSEST TO THE SIGNAL INDICATOR

IMPORTANT! TEST SYSTEM WEEKLY

The manufacturer strongly recommends that you test security equipment frequently. Over a period of time, no electronic products are better than the inspection and maintenence they receive. Therefore, from the time of installation, it is absolutely necessary to test the system at least once a week.

PLACE THE RECEIVER IN A "TEST" MODE AND ACTIVATE THE TRANSMITTTER. VERIFY THAT THE SIGNAL IS RECEIVED AND THAT THE SYSTEM REPORTS AS REQUIRED.

BEEP...

INSTALL THE PENDANT HOLDER THEN CUT AND REMOVE THE NECKLACE

SNAP THE POCKET CLIP INTO THE PENDANT HOLDER

This Linear product is warranted against defects in material and workmanship for twelve (12) months. The Warranty Expiration Date is labeled on the product. This warranty extends only to wholesale customers who buy direct from Linear or through Linear’s normal distribution channels. Linear does not warrant this product to consumers. Consumers should inquire from their selling dealer as to the nature of the dealer’s warranty, if any. There are no obligations

or liabilities on the part of Linear Corporation for consequential damages arising out of or in connection with use or performance of this product or other indirect damages with respect to loss of property, revenue, or proﬁ t, or cost of removal, installation, or reinstallation. All implied warranties, including implied warranties for merchantability and implied

warranties for ﬁ tness, are valid only until Warranty Expiration Date as labeled on the product.

This Linear Corporation Warranty is in lieu of all other warranties express or implied.

For warranty service on Linear equipment return product, at sender’s expense to: Linear Hong Kong 19/F Hounor Industrial Centre, 6 Sun Yip Street Chai Wan, Hong Kong Attention: Repairs Department



Charges will be made for equipment that is not in warranty, shows customer abuse, or is

damaged by the effects of lightning, water, ﬁ re, or other abnormal happenings.  Customer’s equipment sent in for repair may be repaired or replaced with new or remanufactured

equipment at Linear’s discretion.

The customer is always responsible for shipping and handling charges to the repairs facility.



Linear will pay return shipping and handling charges on “in warranty” products shipped back

to the customer. The customer will be billed for the return shipping and handling charges on “out

of warranty” products.



There will be a 50% expedite fee for any express requests. The International Sales Manager must be notiﬁ ed prior to the return of product to Linear. All



international returns must have an International Repair Authorization number (IRA#). The number

must be marked on all packages. Failure to do so will cause delays in processing.

 Linear radio controls provide a reliable communications link and ﬁ ll an impor tant need in portable

wireless signaling. However, there are some limitations which must be observed.  The radios are required to comply with local rules and regulations as radio devices. As such, they

have limited transmitter power and therefore limited range.  A receiver cannot respond to more than one transmitted signal at a time and may be blocked

by radio signals that occur on or near their operating frequencies, regardless of code settings.

 Changes or modiﬁ cations to the device may void regulatory compliance.  Infrequently used radio links should be tested regularly to protect against undetected interference

or fault.  A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale

distributor or dealer, and these facts should be communicated to the ultimate users.

REPAIRS POLICY

IMPORTANT !!!