Linear DXS-10 User Manual

INSTR,INST,DXS-10 LINEAR P/N: 213007 D MATERIAL: 20 LB. MEAD BOND SIZE: 8.500" x 11.000" INK: BLACK SCALE: 1-1
WIRELESS KEYPAD
For Use With DVS-2400 Security Console
Installation Instructions
1. KEYPAD DETAIL 2. TYPICAL WIRELESS KEYPAD PLACEMENT
KEYPAD FOR ENTERING YOUR USER CODE
PRESS THE STAR KEY TO RESET THE KEYPAD IF YOU ENTER THE WRONG CODE
MODE BUTTONS FOR CHANGING MODES
GREEN OPERATION LIGHT
EMERGENCY BUTTON TO SOUND SIREN AT ANY TIME
FIRE BUTTON TO SOUND SIREN AT ANY TIME
KEY TO ACTIVATE HOME AUTOMATION OUTPUT (A)
PRESS AND HOLD FOR 2 SECONDS
TRANSMITTERS
BEDROOM
MAIN CONSOLE
WIRELESS
KEYPAD
WINDOW
KITCHEN
FRONT
ROOM
FRONT
DOOR
3. OPENING KEYPAD 4. TABLE-TOP USE 5. WALL MOUNTING (INDOORS ONLY)
6. CLOSING KEYPAD 7. PROGRAM KEYPAD INTO CONSOLE
LINEAR LIMITED WARRANTY
This Linear product is warranted against defects in material and workmanship for twelve (12) months. The Warranty Expiration Date is labeled on the product. This warranty extends only to wholesale customers
who buy direct from Linear
or through Linear’s normal distribution channels.
Linear does not warrant this
product to consumers.
Consumers should inquire from their selling dealer as to
the nature of the dealer’s warranty, if any.
There are no obligations or liabilities on the part of Linear Corporation for consequential damages arising out of or in connection with use or performance of this product or other indirect damages with respect to loss of property, revenue, or profit, or cost of removal, installation, or reinst allation.
All implied warranties, including implied warranties for merchantability and implied warranties for fitness, are valid only until Warranty Expiration Date as labeled on the product.
This Linear Corporation Warranty is
in lieu of all other warranties express or implied.
All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact Linear Technical Services at 1-800-421-1587 for an RPA# and other important details.
IMPORTANT !!!
Linear radio controls provide a reliable communications link and fill an important need in portable wireless signalling. However, there are some limitations which must be observed.
For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as Part 15 devices. As such, they have limited transmitter power and therefore limited range.
A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio signals that occur on or near their operating frequencies, regardless of code settings.
Changes or modifications to the device may void FCC compliance.
Infrequently used radio links should be tested regularly to protect against undetected interference or fault.
A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor or dealer, and these facts should be communicated to the ultimate users.
Copyright © 2001 Linear Corporation 213007 D
USE THE FOUR SCRATCH DETERRENT PADS PROVIDED FOR TABLE-TOP USE
CONNECT BATTERY TO BATTERY CLIP
FROM TOP OF CASE TWIST SCREWDRIVER BETWEEN CASE HALVES UNTIL IT POPS OPEN
ATTACH REAR CASE TO WALL WITH THE TWO SCREWS PROVIDED
MOUNT AT A CONVENIENT LOCATION NEAR PRIMARY ENTRY/EXIT DOOR
FIRST HOOK BOTTOM EDGE TOGETHER
THEN, SNAP CASE SHUT
2
1
HOLD OFF BUTTON FOR 3 SECONDS WHEN FINISHED TO EXIT LEARN MODE
PRESS STAR KEY TO SEND SIGNAL
ENTER MASTER
USER CODE
PRESS
TEST
ENTER AN
UNUSED SENSOR
NUMBER
SEND SIGNAL
FROM KEYPAD
START IN
TEST MODE
TEST
(760) 438-7000 • FAX (760) 438-7043
USA & Canada (800) 421-1587 & (800) 392-0123
Toll Free FAX (800) 468-1340
www.linearcorp.com
BY
Loading...