Linear 232iLR, 232iLSE Owner's Manual

DOOR-GARD SELF-CONTAINED ACCESS CONTROL SYSTEMS
232R, 232iLR, 232SE and 232iLSE Wiring Diagrams and Specifications

TECHNICAL NOTES

• To avoid ESD (Electro-Static Discharge) interfering with the operation of the
keypad, ground the housing to earth ground.

• The bi-color LED provided with the SE Keypad illuminates red when the Lock­Release relay is de-energized and green when the relay is de-energized.

• When mounting this unit outside, apply silicone to the area where the wires
enter the case. This helps prevent water from entering the case and condensing
on the circuit board. Do not silicone the cover plate because the unit will not
seal properly.

• Do not seal the drain holes at the bottom of the keypad housing. This allows air
to circulate and a place for condensation to drain.

• For use in extreme weather conditions, consult the factory for additional
methods of protecting your keypad.

• To speed installation of the SE Keypad, holes have been spotted on the inside
the back housing for mounting to a wall or a single-gang electrical box.

• On SE Keypad, holes have also been spotted inside the front housing for
additional LEDs (LEDs not included).

SPECIFICATIONS

Case Dimensions:
R Keypad: 3.75”W x 5.25”H x 2.50” D
SE Keypad: 3.00”W x 4.50”H x 1.55”D

Operating Voltage: 12-24V AC/DC (Auto-Adjusting)

Max Current Draw:

Main Relay Contacts (K1): 2A @ 12-24VAC/DC

Auxiliary Relay Contacts (K2, K3 & K4): 1A @ 12-24VAC/DC

Environment: Indoor or Outdoor

Temperature: 232R/232SE: -

232iLR/232iLSE: -4°F to 140°F (-20°C to 60°C)

Voltage
12VDC 50mA 64mA
24VDC 63mA 90mA
12VAC 86mA 104mA
24VAC 108mA 142mA

232R/SE 232iLR/iLSE

31°F to 151°F (-35°C to 66°C)

WARRANTY

International Electronics, Inc. (IEI) warrants its products to be free from defects in
material and workmanship, when they have been installed in accordance with the
manufacturer’s instructions, and have not been modified or tampered with. IEI does
not assume any responsibility for damage or injury to person or property due to
improper care, storage, handling, abuse, misuse, normal wear and tear, or an act of
God.
IEI’s sole liability is limited to the repair or (at IEI’s option) the replacement of the
defective product or part when sent to IEI’s facility (freight and insurance charges
prepaid), after first obtaining IEI’s Return Merchandise Authorization.
IEI will not be liable to the purchaser or anyone else for incidental or consequential
damages arising from any defect in, or malfunction of, its products. This warranty
shall expire two years after shipping date for DOOR-GARD keypads.
Except as stated above, IEI makes no warranties, either express or implied, as to any
matter whatsoever, including, without limitation to, the condition of its products,
their merchantability, or fitness for any particular purpose.

6062320 Rev 1.2

1

Note: If a door position switch is not used, it must be
shorted closed in order for the REX device to work.

6062320 Rev 1.2

INTERNATIONAL ELECTRONICS, INC.
427 TURNPIKE STREET, CANTON, MA 02021 U.S.A.
800-343-9502, 781-821-5566, 781-821-4443 (FAX)

WEB ADDRESS: www.ieib.com

2