Lift-Master WOMODKT User Manual
J500
H2
100A
UD
H2
100A
UD
J406 LCD
J403
D2
3D2
100
16B
3D2
100
16B
3D2
16B
100A
3D2
100
16B
DEVICE 1,2
J401
D300
J402 LED
J200 SPKR
BT300
DEVICE 3,4
J405
Wiegand Module
for EL models
J401
J301
J404
J300
D300
J405
J407
+
BT300
DEVICE 3,4
SW300
3D2
100
16B
UD
D513
UV
OV
H2
100A
16B
100
3D2
J402 LEDJ200 SPKR
D514
J500
H2
100A
UD
3D2
3D2
100
100
16B
16B
3D2
J400
100
16B
DEVICE 1,2
•
Model WOMODKT
J403
J406 LCD
H2
100A
UD
D102
D153
J201
MIC
D2
Caution! A static discharge can
DAMAGE circuit boards.
Wiegand Module
J407 J400
1
Disconnect power to your unit! Unlock and open the unit.
2
Place Wiegand module(s) in J400 Plug - Device 1(J1)and 2(J2) and/or J407 Plug - Device 3(J1) and 4(J2) (4 screws per board).
All wires MUST go through the conduit hole in the back mounting plate of unit.
3
Wiring callouts are under removable wire connectors.
2 modules can be mounted in the EL model.
Supporting up to 4 Wiegand devices.
Connect the shield wire from the device(s) to the backplate or earth ground rod. Some Wiegand devices have a sixth blue wire.
DO NOT connect this blue wire to the unit. Insulate this wire from the unit to prevent a short (refer to instructions supplied with
the Wiegand device for more information). When using an Essex keypad (Chamberlain model # ESSWOKSG), do not connect the brown
LED control wire. Connecting this wire will cause the keypad to work intermittently.
4
After the installation is complete, each device connected to the Wiegand Module(s) must be tested by swiping a card or entering a digit
once, so that the new module is automatically detected. You can then go into programming and assign your devices to the doors.
114A2970C
Device
2 or 4
Callouts
Under Connector
+12V
+5V
DATA 0
DATA 1
LED
COM
J2
J1
J407
Position
J400
Position
Device 4 Device 3 Device 2 Device 1
+12V
COM
+5V
LED
DATA 0
DATA 1
DATA 1
DATA 0
LED
.5V
COM .12V
+12V
COM
+5V
DATA 0
DATA 1
DATA 1
DATA 0
LED
COM .12V
J1J2
© 2006 The Chamberlain Group, Inc.
All Rights Reserved
LED
.5V
J1J2
®
™
Loading...