Lift-Master FIRE RELEASE BOX User Manual

Fire Release Box Installation

This “Fire Release Box”, is designed for use on sliding gates. It consists of a plated box, with doors on the front and back. The doors can be locked with your own padlock, or the fire dept's padlock. The fire box would be fixed to the gate pickets. It can be opened from either side of the gate. A steel cable with a t-handle runs from the box to the release mechanism at the rear end of the chain. We do not provide the 1/2" EMT (electrical metallic tubing) to run the cable through. The release mechanism is placed where the chain bolt would normally be. When you pull on the t-handle, you release the chain. To reconnect the chain, simply reinsert the pin into the housing for normal operation.

“T” Handle

1/2" EMT Connector

(Included)

1/2" EMT

(Not Included)

01-50636

Gate Chain

For Technical Support: 1-800-528-2806

The chain is held in place by s spring loaded pin

1/2" EMT

Connector

(Included)

Steel

Cable

Chain

845 Larch Avenue Elmhurst, Illinois 60126

www.chamberlain.com

Bracket

™