Lift-master CVRDGRST6 User Manual

845 Larch Avenue, Elmhurst, Illinois 60126

www.chamberlain.com

™

Gate Wheel and Roller Guide Covers

for slide gates

Instructions for models CVRPWST4, CVRPWST6, CVRPWAL6, CVRGRST6 and CVRDGRST6

Cut gate frame and weld gate wheel cover to gate frame.

Gate Wheel Cover

Gate Frame

Double Roller Guide Cover

Weld gate wheel cover to the bottom of gate frame.

Position roller guide cover so the cap is on top. Weld roller guide cover to gate post and roller support guide post.

Position roller guide cover so the cap is on top. Weld double roller guide cover to roller support guide post.

Gate Wheel

Bolt

Nut

Gate Wheel Cover

OROR

Roller Support Guide Post

Gate Frame

Roller Guide Cover

Roller Guide

Cap

Gate Post

Gate Frame

Roller Support Guide Post

01-33731B

Roller Guide

Roller Guide Cover

Roller Guide

• Injuries occur when people get their hands or feet caught between the top or bottom of the gate and the gate roller. These potential pinch-points should be guarded against at all times. Enclosed style gate tracks are available for refitting of these rollers from many fence suppliers. Also, roller guards are available for installing over the rollers.

• UL325 requires that, when used, contact sensors shall be located at the leading edge, trailing edge, and be post mounted both inside and outside of a vehicular horizontal slide gate. Non-contact sensors such as photo eyes must protect during both open and close gate cycles.

• Injuries occur when people put their hands and arms through openings in the grill while the gate is operating. They cannot retract their arm and it gets caught between the moving gate grill and the stationary fence post or fence. This potential hazard can be averted by placing a 4' (1.2 m) screen mesh on the gate to prevent access through openings anywhere the gate may travel. See Safety Brochure for details. To prevent entrapment injuries, mount controls at least 6' (1.8 m) from the gate or any moving parts of the gate.

WARNING