CLUB SERIES 45 DEGREE
BACK EXTENSION
Part # 7199901
Rev A.
ASSEMBLY INSTRUCTIONS
Revision:10/19/011
PARTS LIST
HARDWARE BAG:
ACUHB-CS45XPLT
-orACUHB-CS45XWHT
KEY
1
2
3
4
5
6
7
8
PART #
72000
72006
72012
72015
69132
3202403
3102904
3233301
DESCRIPTION
FRAME
HIP P AD ADJUST
SUPPORT
FORMED ANGLE
HIP PAD
3/8 X 2-3/4” BUTTON HEAD
3/8 X 3” BOLT
5/16 X 1/2” SHOULDER BOLT
T ools Required for Assembly
* Rubber mallet or hammer
* 9/16” wrench
* Ratchet with 9/16” socket
QTY
1
1
2
1
2
2
4
1
KEY
9
10
11
12
13
14
15
OR
PART #
3226701
3102905
3102807
3102514
6866701
3228501
6866602
6866603
DESCRIPTION
1/4” LOCK WASHER
3/8 X 3-3/4” BOLT
3/8” LOW HEIGHT LOCK NUT
3/8” SAE WASHER
3/8” RH WASHER
3/8” BLACK SAE WASHER
WHITE RH CAP
PLA TINUM RH CAP
QTY
1
4
6
10
14
2
14
14
NOTE: BOL T LENGTH IS MEASURED FROM THE UNDERSIDE OF THE HEAD OF THE BOLT .
Bolt Length Ruler
BOLT LENGTH
1/2 1/2 1/2 1/2 1/2 1/2
0
1
2
345
2
6
7 3/8 X 3” BOLT
10 3/8 X 3-3/4” BOLT
6 3/8 X 2-3/4” BUTTON HEAD BOLT
11
3/8” LOW
HEIGHT LOCK
NUT
12
3/8” SAE
WASHER
8 5/16 X 1/2” SHOULDER HEAD BOLT
13
RH
WASHER
15
RH CAP
(WHITE/PLATINUM)
14
3/8” BLACK SAE
WASHER
9
LOCK
WASHER
3
FIGURE 1
1
11
13
3
3/8 X 3-3/4” 10
12
15
STEP 1:
• SECURELY assemble the two SUPPORTS (3) to the FRAME (1) using eight RH CAPS (15), four 3/8 X 3-3/4” BOLTS (10),
eight 3/8” SAE WASHERS (12), eight 3/8” RH WASHERS (13) and four 3/8” LOW HEIGHT LOCK NUTS (11) as shown in
FIGURE 1.
1/2 1/2 1/2 1/2 1/2 1/2
0
1
2
345
4
6
FIGURE 2
2
SPRING PIN
1
6 3/8 X 2-3/4” BUTTON HEAD
14 BLACK
4
13
12
11
15
STEP 2:
• Pull back the SPRING PIN on the FRAME (1) and insert the HIP PAD ADJUST (2) as shown in FIGURE 2.
• SECURELY assemble the FORMED ANGLE (4) to the FRAME (1) using two 3/8 X 2-3/4” BUTTON HEAD BOLTS (6), two 3/8”
BLACK SAE WASHERS (14), two 3/8” RH WASHERS (13), two 3/8” SAE WASHERS (12), two 3/8” LOW HEIGHT LOCK
NUTS (11) and two RH CAPS (15) as shown in FIGURE 2.
5
FIGURE 3
2
9
8 5/16 X 1/2”
SHOULDER
BOL T
STEP 3:
• SECURELY assemble one 5/16 X 1/2” SHOULDER BOLT (8) and one 1/4” LOCK WASHER (9) to the HIP PAD ADJUST (2) as
shown in FIGURE 3.
1/2 1/2 1/2 1/2 1/2 1/2
0
1
2
345
6
6
FIGURE 4
15
3”
5
3/8 X 3” 7
13
2
STEP 4:
• SECURELY assemble the two HIP PADS (5) to the HIP PAD ADJUST (2) using two RH CAPS (15), two 3/8 X 3” BOLTS (7) and
two 3/8” RH WASHERS (13) as shown in FIGURE 4. (Note the the direction of the hole pattern on pad.)
7
CAUTION-PLEASE READ
There is a risk assumed by individuals who use this type of equipment. To minimize risk, please
follow these rules:
1. Inspect equipment daily . Tighten all loose connections and replace worn parts immediately.
Failure to do so may result in serious injury.
2. Do not allow minors or children to play on or around this equipment.
3. Exercise with care to avoid injury .
4. Consult your physician before beginning any exercise program.
WARRANTY INFORMATION
10 YEARS STRUCTURUAL FRAME
3 YEARS PILLOW BLOCKS, PULLEYS, WEIGHT PLA TES AND GUIDE RODS
1 YEAR CABLES
90 DA YS UPHOLSTERY
PREVENTATIVE MAINTENANCE TIPS
Action DAILY WEEKLY QUARTERLY BI- ANNUALLY AS NEEDED
CLEAN
Uphol s tery
Guide Rods
Hand Grips
INSPECT
Visual Over all
Cabl e s
Hardware
Frame
Hand Grips
LUBRICATE
Guide Rods
X
X
X
X
X
X
X
X
X
Clean:
• Upholstery with mild soap and water.
• Guide rods with a cotton cloth.
• Hand grips with mild soap and water.
• Frame damage can be repaired with touch-up paint can be purchased from your LifeFitness customer service representative at
(800)351-3737.
Inspect:
• Cables for wear or damage and proper tension (should not exceed 3/4” deflection.) Pay close attention at bends and attachment
points.
• Hardware should be checked for looseness. Tighten as required.
• Frames should be inspected for wear or damage.
• Hand Grips should be checked for wear or damage
Lubricate:
• Lube the Guide Rods. Apply the lubricant to a cotton cloth, then run the cotton cloth up and down the guide rods as needed. Do not
spray lubricant directly on the Guide Rods.
Thank you for purchasing the LifeFitness CLUB SERIES 45 DEGREE BACK EXTENSION. If unsure of
proper use of equipment, call your local LifeFitness distributor or call the LifeFitness customer service
department at (800) 351-3737.
8
Loading...