Side by Side
Installation
HCB 1561 together with HCB 1560
HC 1551 together with HC 1550
HC 1541 together with HC 1540
7083 393-00
Parts list of SBS Installation Kit
Image Article number Name of the item
6943 651-00 Heating blanket
9005 441-00 Guide plate
9693 583-00 Top connecting plate
9693 585-00 Bottom angle bracket
9190 171-00 Top cover
2
Image Article number Name of the item
7641 503-00 Sealing strip
4098 066-01 Pan head screws 6 x 25
7083 393-00 Installation manual
Other parts used in this installation manual are supplied with the appliance, not with the SBS Kit.
3
Side by Side (SBS) Installation
WARNING!
Risk of fire or damage.
The accessory is intended for use only
with a refrigerator that is marked to
indicate such use.
This kit may only be installed with models
HCB 1561, HC 1551, HC 1541
CAUTION!
The Side by Side installation should only be done by
a trained expert. We recommend this procedure be
done by two people.
IMPORTANT
The water supply lines for both appliances must be
located already in their correct positions as shown
in chapter „Cabinet opening dimensions“ in the
installation instructions or design guide.
WARNING!
Electrocution hazard.
The refrigerator must be disconnected
from the source of electrical supply before
attempting the installation.
Mount the anti tipping brackets for both
1.
appliances.
Refer to chapter
Mounting the anti tipping device
in the installation instructions.
Remove the protective foil of the double-
2.
sided adhesive strips on the bottom of
the guide plate. The guide plate is supplied with the SBS kit.
IMPORTANT
Make sure, that the floor is clean (dust and
grease free), for the adhesive tape.
Adhere the guide plate on the floor. The rear
3.
edge of the plate must have contact with the
anti tipping brackets. Mark a center line on
the floor as illustrated and align the center of
the guide plate with this line.
NOTE
The guide plate may also be fastened with screws
through any hole wherever. The screws are not provided with the appliance or the kit.
2.
1.
1.
3.
4