LG Electronics SXS User Manual

Vennligst les denne bruksanvisningen n¿ye og s¿rg for den bestandig er tilgjengelig som referanse.

L¾s venligst vejledningen grundigt,  inden kombiskabet tages i brug,  og gem den til fremtidig reference.

Ls igenom denna anvndarhandbok innan du brjar anvnda kylen/frysen och spara den sedan fr att kunna ta fram den vid behov.

Table of contents

Entry

Important safety instruction

Identification of parts

Where to install

Door removal

Door replacement

Feed water pipe installation

Height adjustment

Starting

Adjusting the temperatures and functions

Automatic ice maker and dispenser

Refreshment center (Applicable to some models only)

Wine holder(Applicable to some models only)

Egg box

Humidity control in the vegetable compartment

Convert into a vegetable or meat compartment

Deodorizer (Applicable to some models only)

Location of foods

Storing foods

How to dismantle parts

General information

Cleaning

Trouble shooting

Introduction

Installation

Operation

Suggestion on

food

storage

Care and

maintenance

15 16

Entry

The model and serial numbers are found on the inner case or back of refrigerator compartment of this unit. These numbers are unique to this unit and not available to others. You should record requested information here and retain this guide as a permanent record of your purchase. Staple your r eceipt her e.

Date of purchase : Dealer purchased from : Dealer address : Dealer phone no. : Model no. : Serial no. :

Before it is used, this refrigerator must be properly installed and located in accordance with the installation instructions in this document.

Never unplug your refrigerator by pulling on the power cord. Always grip plug firmly and pull it straight out from the outlet.

When moving your appliance away from the wall, be careful not to roll over the power cord or to damage it in any way.

After your refrigerator is in operation, do not touch the cold surfaces in the freezer compartment

, particularly when your hands are damp or wet. Skin could adhere to

these extremely cold surfaces. Unplug the power cord from the power outlet for cleaning or other requirements. Never

touch it with wet hands because you can get an electric shock or be hurt. Never damage, process, severely bend, pull out, or twist the power cord because

damage the power cord may cause a fire or electric shock. You have doubts on whether the appliance is properly grounded.

Never place glass products in the freezer because they may be broken due to expansion when their contents are frozen.

Never allow your hands within the ice storage bin of the automatic ice maker. You could be hurt by the operation of the automatic ice maker.

The appliance is not intended for use by young children or infirm persons without supervision.

Young childeren should be supervised to ensure that they do not play with the appliance.

Never allow anyone to climb, sit, stand or hang on the refreshment center door. These actions may damage the refrigerator and even tip it over, causing severe personal injury.

If possible, connect the refrigerator to its own individual electrical outlet to prevent it and other appliances or household lights from causing an overload that could cause a power outage.

The refrigerator-freezer should be so positioned that the supply plug is accessible for quick disconnection when accident happens.

If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.

Introduction

Important safety instruction

Don’t use an

extension cord

Accessibility of

Supply Plug

Supply Cord

Replacement

Identification of parts

DANGER: Risk of child entrapment. Before you throw away your old refrigerator or freezer: Take off the doors but leave the shelves in place so that children may not easily climb inside. The appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance.

Don’t store or use gasoline or other flammable vapor and liquids in the vicinity of this or any other appliance.

In the event of an electric short circuit, grounding (earthing) reduces the risk of electric shock by providing an escape wire for the electric current. In order to prevent possible electric shock, this appliance must be grounded improper use of the grounding plug can result in an electric shock. Consult a qualified electrician or service person if the grounding instructions are not completely understood, or if you have doubts on whether the appliance is properly grounded.

Child entrapment

warning

Don’t store

Grounding (Earthing)

Introduction

•

If you found some parts missing from your unit, they may be parts only used in other models. (i.c. the “Refreshment center” is not included in all models)

NOTE

Freezer compartment

Refrigerator compartment

Milk product corner

Door rack

Lamp

Automatic

ice maker

Shelf

(steel or glass)

Door rack

Drawer

(1 or 2)

Shelf

Door rack

Lower cover

Lamp

Shelf Door rack

(1 Piece or 2 Piece)

Door rack (1 Piece or 2 Piece)

Shelf Snack drawer

Refreshment center (Optional)

Egg box

Vegetable drawer Door rack

Vegetable drawer/Meat drawer

Humidity switch

Conversion switch (Meats/Vegetables)

Wine holder (Optional)

Installation

Select a good

location

Where to install

1. Place your appliance where it is easy to use.

2. Avoid placing the unit near heat sources, direct sunlight or moisture.

3. Air must circulate properly around your appliance to ensure efficient operation. If your appliance is placed in a recessed area in the wall, allow at least a 12 Inches (30 cm) or greater clearance above the appliance and 2 inches (5 cm) or more from the wall. The appliance should be elevated 1 inch (2.5 cm) from the floor, especially if it is carpeted.

5. Don't install the appliance below 5°C. It may cause affect the performance.

4. To avoid vibrations, the appliance must be leveled.

Door removal

Failure to do so could result in death or serious injury.

If your access door is too narrow for the refrigerator to pass through, remove the refrigerator door and pass the refrigerator laterally.

Electric Shock Hazard

Disconnect electrical supply to refrigerator before installing.

Remove the lower cover by lifting upward, and then pull up the feed water tube while pressing area shown in the figure to the right.

Remove lower

cover and

then feed water

tube

Warning

Remove the

freezer

compartment

door

Remove the

refrigerator

door

Installation

1) Removing the hinge cover by loosening the

screws. Separate all connection wires except for the earth line after.

2) Remove the keeper by rotating it counter

clockwise (

)

and then lifting the upper

hinge up(

).

3) Remove the freezer compartment door by

lifting it upward. This time, the door should be lifted enough for the feed water pipe tube to be completely pulled out.

1) Loosen the hinge cover screws and remove

the cover. Remove connection wire, if any, except for the earth line.

2) Remove keeper by rotating it clockwise (



) and then remove the upper hinge by lifting it up (



3) Remove the refrigerator compartment door by lifting it up.

•

If a tube end is deformed or abraded, cut the part away.

NOTE

•

When removing the upper hinge, be careful that the door does not fall forwards .

NOTE

•

Move the refrigerator compartment door passing through the access door and lay it down, but be careful not to damage the feed water pipe tube.

NOTE

Lower cover

Lower hinge

Keeper

Feed water tube

Connection wires

Connection

wires

Hinge cover

Upper hinge

Keeper

Upper hinge

Earth line

Door replacement

Feed water pipe installation

Pass the refrigerator laterally through the access door as shown in the right figure.



Automatic ice maker operation needs water pressure of 147~834 kPa (1.5~8.5 kgf/cm2) (That is, an instant paper cup (180 cc) will be fully filled within 3 sec.).



If water pressure does not reach the rating 147 kPa (1.5 kgf/cm2) or below, it is necessary to purchase a separate pressure pump for normal automatic icing and cool water feed.



Keep the total length of the feed water pipe tube within 8 m and be careful for the tube not be bent. If the tube is 8 m or longer it may cause trouble in water feed owing to the drain water pressure.



Install the feed water pipe tube at a place free from heat.



Connect to potable water supply only.



Refer to instructions with water filter kit for installation.

This appliance contains fluid (refrigerant, lubricant)and is made of parts and materials which are reusable and/or recyclable. All the important materials should be sent to the collection center of waste material and can be reused after rework (recycling). For take back, please contact with the local agency.

Mount them in the reverse sequence of removal after they pass through the access door.

Pass the

refrigerator

Before

installation

Warning

Disposal of the

old appliance

Ma x

M P RE F TE M P

M i n

M a x

Installation

Height adjustment

Level the door by inserting flat (

type) driver into the groove of the left height adjusting

screw and rotate it clockwise ().

Level the door by inserting flat (

type) driver into the groove of the right height

adjusting screw and rotate it clockwise ().

The refrigerator doors will close smoothly by heightening the front side by adjusting the height adjusting screw. If the doors do not close correctly, performance may be affected.

If the freezer

compartment door

is lower than the

refrigerator

compartment door

If the freezer

compartment door

is higher than the

refrigerator

compartment door

After leveling the

door height

Installation



1. Wipe off all dust accumulated during shipping and clean your appliance thoroughly.

2. Install accessories such as the ice cube box, cover evaporating tray, etc., in their

proper places. They are packed together to prevent possible damage during shipping.

3. Connect the power supply cord (or plug) to the outlet. Don't double up with other

appliances on the same outlet.

Starting

Adjusting the temperatures and functions

When your refrigerator is first installed, allow it to stabilize at normal operating temperatures for 2-3 hours prior to filling it with fresh or frozen foods. If operation is interrupted, wait 5 minutes before restarting.

Operation

+ 19 hidden pages