LG PBSC30 INSTALLATION INSTRUCTIONS

Suction Canvas Installation Manual(for Built-in duct suction grille)

<![if ! IE]>

<![endif]>ENGLISH

Screws for adjusting chain	8	8
Installation manual	1	1	Indoor unit

2. Require tools

Screwdrivers, Nippers

3. Installation procedures		1
	2	Fig.1

1) Install the air suction canvas

Tighten two fixing bolts for air suction canvas to the indoor unit.

Fit the air suction canvas over the fixing bolts and slide the direction of the arrow in Fig.2 to hang the air suction canvas on the indoor unit.

Fit the remaining two fixing bolts and tighten all four fixing bolts until the seal is about 3~5mm thick.

2) Adjust the air suction canvas height

Attach the suction outer grille. For details, see the installation provided with the suction grille.

Hook the four adjusting chain over upper part of suction canvas in Fig.3 (a).

Check the suitable point in the adjusting chain that makes close the gap between the ceiling surface and the suction grille.

Hook the four adjusting chain with checked point over lower part of suction canvas in Fig.3 (b), cut any extra adjusting chain with the nippers.

If you want more hard fixing, you can also use the fixing screws for fixing adjusting chain with upper and lower hook.(Fig.4)

1 2

Fig.2

(a) Upper hook

Adjusting chain

(b) Lower hook

Air suction canvas

Fixing Bolt

M5 X 18

Additional fixing hole

Fig.3

Fig.4