LG LW71105SS Owner’s Manual

Built In Oven

Installation and Operating Instructions

LW71105SS

To avoid the risk of accidents or damage to the oven,
it is essential to read these operating instructions
before it is installed or used for the first time.
And please keep this manual for later reference.

P/No.: MFL62060308

http://au.lge.com (Australia)
http://nz.lge.com (New Zealand)

Contents

Instructions for safety and user ................................................ 3

1. Instructions for safety and use ................................................ 3

Instructions for the installer ...................................................... 6

2. Installation .............................................................................. 6

Instructions for the user ............................................................ 8

3. Description of controls............................................................. 8

4. Using the oven ...................................................................... 13

5. Available accessories ........................................................... 15

6. Cooking hints ........................................................................ 16

7. Cleaning and maintenance ................................................... 24

8. Extraordinary maintenance ................................................... 29

INSTRUCTIONS FOR THE INSTALLER: these are intended for the
authorised person who must install the appliance, set it
functioning and carry out an inspection test.

INSTRUCTIONS FOR THE USER: these contain user advice,
description of the commands and the correct procedures for
cleaning and maintenance of the appliance.

2

1. Instructions for safety and use

This manual is an integral part of the appliance and therefore must
be kept in its entirety and in an accessible place for the whole
working life of the oven. We advise reading this manual and all the
instructions therein before using the oven. Installation must be
carried out by qualified personnel in accordance with the
regulations in force. This appliance is intended for domestic uses
and conforms to the EEC directives currently in force. The
appliance has been built to carry out the following functions:
Cooking and heating-up of food. All other uses are considered
improper.

The manufacturer declines all responsibility for improper use.

Do not discard packing in the home environment. Separate the
various waste materials and take them to the nearest special
garbage collection centre.

The appliance must be connected to earth in compliance with
electrical system safety regulations.

When linking up to mains by plug and socket, make sure that both
are compatible and connect by means of a power cable complying
with applicable regulations and power requirements.
The socket must be accessible after the appliance is built in.

Never unplug by pulling on the cable.

Do not obstruct ventilation openings and heat dispersal slits.

3

Instructions for safety and user

Instructions for safety and user

Immediately after installation carry out a brief inspection test of
the oven, following the instructions below. Should the appliance
not function, disconnect it from the power supply and call the
nearest technical assistance centre.

Never attempt to repair the appliance.

Always check that the control knobs are in the “ZERO”(OFF)
position when you finish using the oven.

Never put inflammable objects in the oven: If it should accidentally
be switched on, this might cause a fire.

During use the appliance becomes very hot. Take care not to
touch the heating elements inside the oven.

The I.D plate with technical data, serial number and brand name is
positioned visibly on the oven door frame.

The plate must never be removed.

The use of this appliance is not permitted to people (including
children) of reduced physical and mental ability, or lacking in
experience in the use of electrical appliances, unless they are
supervised or instructed by adults or people responsible for their
safety.

This appliance is designed for cooking food in a domestic
application and it shall not be used as a space heater.

Do not spray aerosols in the vicinity of this appliance while it is in
operation.

4

Before the appliance is put into operation, all labels and protective
films applied inside or outside must be removed with the exception
of the rating I.D. label.

The manufacturer declines all responsibility for damage to
persons or things caused by the non-observance of the above
prescriptions or deriving from tampering with any part of the
appliance or by the use of non-original spares.

5

Instructions for the installer

2. Installation

2.1 Electrical connection

Make sure the voltage and the cross-section of the power cord
match the specifications indicated on the identification plate
positioned on the frame of the oven door. Do not remove this

plate for any reason.

The appliance must be connected to earth in compliance with
electrical system safety regulations.

If a plug and socket connection is being used make sure that the
plug and socket are compatible. Avoid use of adapters and shunts
as these could cause overheating and burns. Extension leads must
not be used.

If a fixed connection is being used, fit the power line with an
omnipolar circuit breaker or isolation switch with a contact opening
gap equal to or greater than 3 mm, in an easily accessible position
close to the appliance.

For operation on 220-240V~ : use an
H05RR-F / H05RN-F type three-core cable
(3 x 1.5 mm

2

).

The end to be connected to the appliance
must be an earth wire (yellow-green) at
least 20 mm longer.

The manufacturer declines all responsibility for damage to
persons or things caused by non-observance of the above
prescriptions or by interference with any part of the appliance.

6

2.2 Positioning the oven

The oven is designed for mounting into any piece of furniture as long
as it is heat-resistant. Proceed according to the dimensions shown
in Figures 1, 2 and 3. For installing under a work top, follow the
dimensions given in Figure 1-3. For installing under a work top with
combined cooking hobs, ensure a minimum clearance from any side
walls of at least 110 mm as shown in Figure 1. When installing in tall
units, comply with the dimensions shown in figure 1-2, bearing in
mind that the top/rear of the unit must have an opening 80-90 mm
deep. Tighten the 4 screws A inside the frame (fig. 1).
For installing beneath a countertop hob, allow for a rear and bottom
clearance as shown in Figure 1 (ref. B). See the relevant
instructions for fitting and securing the hob.

Never use the oven door to lever the oven into
place when fitting.
Avoid exerting too much pressure on the oven
door when open.
The oven door should not be used as a resting
table for food being removed or put in to the oven.

7

8

Instructions for the user

3. Description of controls

3.1 The front panel

All the oven controls are grouped together on the front panel.

At first use or after a power outage, press the centre button
for 1/2 seconds to enable the oven for cooking.

FUNCTIONS SWITCH KNOB

Turn the knob in either direction to select a function
from the following:

No function selected

Upper and lower
heating element

Wide grill element +
Rotisserie function.

Narrow grill element +
Rotisserie function

Grill element
+ Ventilation

Lower heating element
+ Fan-Assisted heating element

Fan-Assisted heating
element

Upper and lower
heating element + Ventilation

Lower heating element
+ Ventilation

9

THERMOSTAT KNOB

The cooking temperature is selected by turning the
knob clockwise to the desired setting, between 50°
and 250°C.

THERMOSTAT INDICATOR LIGHT (ORANGE)

The light comes on to indicate that the oven is heating up.
When it goes out, the preset heating temperature has
been reached.
When the light turns on and off regularly it means that the
temperature inside the oven is kept steady on the
set level.

INDICATOR LIGHT (GREEN)

This light comes on when any element of the oven is
powered on.