ELECTRIC SHOCK, DO NOT REMOVE THE
COVER (OR BACK). NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
The lightning flash with the arrowhead symbol
within an equilateral triangle is intended to alert
the user about the presence of uninsulated
dangerous voltage within the product’s enclosure
that may be of sufficient magnitude to constitute
a risk of electric shock.
The exclamation point within an equilateral
triangle is intended to alert the user to
the presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
Always operate the vehicle in a safe manner. Do
not be distracted by the vehicle while driving and
always be fully aware of all driving conditions.
Do not change settings or any functions.
Pull over in a safe and legal manner before
attempting such operations.
To promote safety, certain functions are disabled
unless the parking brake is on.
To reduce the risk of electric shock, do not
remove the cover or back of this product. There
are no user-serviceable parts inside. Refer
servicing to qualified service personnel.
To reduce the risk of fire or electric shock, do
not expose this product to dripping or splashing
water, rain, or moisture.
When driving your vehicle, be sure to keep the
volume of the unit low enough to allow you to
hear sounds coming from the outside.
Do not drop it and avoid heavy impacts at
anytime.
The driver should not watch the monitor while
driving. If the driver watches the monitor while
driving, it may lead to carelessness and cause an
accident.
•Don’t use a mobile phone when you are driving.
You must stop at a safe place to use a mobile
phone.
•The use of the navigation radio by no means
relieves the driver of his/her responsibilities.
The highway code must always be observed.
Always observe the current traffic situation.
•The applicable traffic regulations and the
prevailing traffic situation always take
precedence over the instructions issued by
the navigation system if they contradict one
another.
•For traffic safety reasons, use the navigation
system menus only before starting a journey or
when the vehicle is stationary.
•In certain areas, one-way streets, turn-off,
and entry prohibitions (e.g. pedestrian zones),
the navigation system will give a warning. Pay
particular attention to these kind of cases.
•The navigation system does not take the
relative safety of the suggested routes into
consideration:
Road blocks, building sites, height or weight
restrictions, traffic or weather conditions or
other influences which affect the route safety
or travel time are not taken into consideration
for the suggested routes. Use your own
discretion in order to decide on the suitability
of the suggested routes.
•The current legal road traffic speed limit always
takes priority over the values saved in the
data. It is impossible to provide an assurance
that the speed values of the navigation system
will always match those of the current traffic
regulations in every situation.
•Do not rely exclusively on the navigation
system when attempting to locate an
emergency service (hospital, fire service etc.).
It cannot be guaranteed that all available
emergency services in your vicinity are saved
in the database. Use your own discretion and
abilities to secure help in such situations.
CAUTION:
•Do not keep the navigation system running with
the engine stopped. Doing so may discharge the
vehicle battery. When you use the navigation
system, always keep the engine running.
•Do not disassemble or modify this system.
If you do, it may result in accidents, fire, or
electrical shock.
•Some states/provinces may have laws limiting
the use of video screens while driving. Use the
system only where it is legal to do so.
•Take precautions regarding static electricity
when connecting/disconnecting external USB
devices.
•Encoded MP3 players will not be recognised
when connected as an external device.
•When connecting an external USB device, the
device may not properly recognise the USB is
in some states.
•USB devices formatted as FAT 16/32, exFAT or
NTFS are supported.
- Read: FAT 16/32, exFAT, NTFS
- Write: FAT 16/32 (It may be limited when
using the POI export function.)
•Some USB devices may not be supported due
to compatibility issues.
•Avoid contact between the USB connector and
bodily parts/foreign objects.
•Repeated connecting/disconnecting of USB
devices within short periods of time may result
in product malfunction.
•The amount of time required to recognise the
external USB device may differ depending on
the type, size, or file formats stored on the
USB. Such differences in required time are not
indications of malfunction.
•The device may not recognise the USB device if
separately purchased USB hubs and extension
cables are being used. Connect the USB directly
with the multimedia terminal of the vehicle.
•When application programmes are installed to
specific USB, files may not properly play.
•The device may not operate normally if MP3
players, mobile phones, digital cameras, or other
electronic devices (USB devices not recognised
as portable disk drives) are connected with the
device.
•Charging through the USB may not work for
some mobile devices.
•The device may not support normal operation
when using a USB memory type other than
metal cover type USB memory.
•The device may not support normal operation
when using formats such as HDD type, CF, or
SD memory.
•The device will not support files locked by DivX
DRM (Digital Rights Management).
•USB memory sticks used by connecting an
adaptor (SD type or CF type) may not be
properly recognised.
•It may not properly work depending on the
storage type.
Using iPod devices
Precautions upon using iPod
iPod® is a registered trademark of Apple Inc.
•Some iPods with unsupported communication
protocols may not properly operate with the
system.
•If the iPod malfunctions due to an iPod device
defect, reset the iPod and try again. (To learn
more, refer to your iPod manual.)
•During ACC ON state, connecting the iPod
through the iPod cable (The cable that is
supplied when purchasing iPod/iPhone
product.) will charge the iPod through the
system. (However, iPad is not charged.)
•The use of genuine iPod cables supplied by Apple
is recommended. (The use of other products
may result in noise or abnormal operation.)
•With some iPhones, streaming audio and iPod
control may occasionally conflict. If problems
persist, remove the iPhone and connect again.
•Use iPod with complete synchronisation to
iTunes. Unauthorised song addition may cause
abnormal operation.
•If iPod and Bluetooth are connected
simultaneously with the same iPhone, you
cannot use Bluetooth audio function.
•If iPod touch or iPhone is used, iOS5.0 or a
later version is recommended.
Supported iPod devices
iPhoneX
iPhone8, iPhone8 Plus
iPhone7, iPhone7 Plus
iPhoneSE, iPhone6, iPhone6 Plus,
iPhone6s, iPhone6s Plus
iPhone5C, iPhone5S, iPhone5
iPhone4S, iPhone4
iPhone3GS, iPhone3G, iPhone
•Ejecting and inserting SD cards while the system is
operating may result in SD card or system errors.
To eject or insert the SD card, first turn off the
system and the vehicle should be off status.
•Eject/insert SD cards only to update the map
with a new version.
•When an SD card with the new version of
update software is installed, then the system
will reboot automatically.
Usage of SD cards
•The SD card is formatted to include only map
and new navi S/W.
•The SD card cannot be used to save and play
music.
•Do not add, delete, or format files within the SD
card.
- AM mode: Plays previous/next available
frequency.
- FM mode: Plays previous/next available
station existing within [List] menu. (If
there is no or one station in [List] menu,
the “Auto tuning” function is executed.)
- MEDIA mode:
•When it is pressed for a short time: Plays
previous/next file.
•When it is pressed and held: Rewinds
or fast forwards the file. (except for
Bluetooth and Android Auto)
8. (Custom button)
Press to go to the [Custom button settings]
menu. After setting, press to use desired
function.
9. SETUP button
Press to go to the [Settings] menu.
10. button
- AM mode: Turn left/right to tune manually.
- MEDIA mode (except for Bluetooth, Apple
CarPlay and Android Auto): Turn left/
right to search for the desired file and press.
- Navigation mode: Turn to the left/right to
change the map scale on the map screen.
11. Reset hole
Press with a thin object to reset the unit
when it does not operate normally.
1. Press the engine start button or set the
ignition key to On or ACC.
Once the system is turned on, the booting
process will start and the safety warning
page is displayed.
2. Press [Confirm].
If you want to change the system language,
press [Language]. For more details, refer to
“Language” on page 55.
Notes
•You cannot operate the system while it is
booting up. It may take some time for all of the
features to be ready.
•The safety warning page is displayed every
time the ignition is turned on. The displayed
warnings are related to safety, please closely
read and comply with the safety warnings.
•If there is no operation for 10 seconds in the
safety warning screen the system automatically
switches to the last played mode.
Turning the system on
Press [1] on the head unit in system OFF
status.
Turning the system off
Press and hold [1] on the head unit in system
ON status.
AV OFF
Press [1] on the head unit to turn AV off in
power ON status.
AV ON
Press [1] on the head unit to turn AV on in AV
OFF status.
Adjusting the volume
Turn the volume control knob (-) on the head
unit to the left/right.